Overview
The GEN2 SRC Front Bumper, part number S/B77724, is a full-width powder-coated steel front bumper for the 2018–2026 Jeep Wrangler (JL) and the 2020–2026 Jeep Gladiator. It is winch compatible and includes D-ring mounts. The Gen2 design offers greater fender-to-fender protection than the original SRC.
The bumper is made from 3/16″ cold rolled steel. Its corners extend to match the factory fender lines, and the raised corners give better entry and exit angles in extreme conditions. The bottom and sides are reinforced with replaceable PP+TPO slip strips, which Smittybilt says add an extra 5/16″ of damage protection.
Key features
- Full-width design with corners that extend to the factory fender lines
- Raised corners for better entry and exit angles
- Replaceable PP+TPO slip strips that add 5/16 inch of damage protection
- Solid D-ring mounts welded on the inside and outside, with integrated recovery points
- Winch compatible, with light mounts included
Choosing the right front bumper
A front bumper is often the first point of contact on rocks, brush and trail debris, so the design matters. A full-width bumper protects more of the front end, while the corners and the bottom edge decide how the vehicle approaches obstacles. Think about how you use the vehicle before choosing between a full-width and a narrower bumper.
Weight is part of the decision too. Steel adds mass at the front, which changes steering feel and load on the front axle and suspension. Pair the bumper with a winch only if the front end and the mounts can handle the added load, and plan for the wiring and lights before the bumper is installed.
- Check winch compatibility before buying a winch
- Plan light wiring before mounting
- Inspect slip strips after rocky trail use
- Confirm the front axle load with the added weight
Specifications
| Brand | Smittybilt |
|---|---|
| Model | GEN2 SRC Front Bumper |
| Part number | S/B77724 |
| Position | Front |
| Width | Full |
| Material | Steel, 3/16″ cold rolled |
| Finish | Powder coat |
| Winch mount | Compatible |
| D-ring mounts | Included |
| Light mounts | Included |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2018–2026 Jeep Wrangler (JL) and the 2020–2026 Jeep Gladiator.
The list does not include the Wrangler JK, TJ or LJ, the 2007–2018 model years, or any model year after 2022. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The D-ring mounts are welded in place, and the bumper is a direct fit for the listed models. The slip strips are replaceable, so worn ones can be swapped without replacing the whole bumper.
What’s included
The SRC Gen2 front bumper with its D-ring mounts and slip strips.
Light mounts are the brackets that lights attach to. The lights themselves need to be sourced separately if you plan to add them.





















