Overview
The Skyjacker Softride Hydro Shock Absorber H7058 is a hydraulic twin tube shock that can be used at the front or rear of a vehicle. It is intended for suspension lift kits in the 3.5 to 5 in range and fits a broad mix of Chevrolet, Dodge, Ford, GMC, Jeep, Mazda, Mitsubishi, Nissan and Toyota trucks and SUVs.
The shock uses multi-stage velocity sensitive valving inside a heavy-duty twin tube body. Its 5/8 inch hardened double chrome rod works with red polyurethane bushings and a red boot. Recommended CJ setups use a 4 inch lift, with front or rear use on 1955–75 CJ models and rear use on 1976–86 CJ models.
Key features
- Multi-stage velocity sensitive valving
- Hydraulic action with variable resistance
- Heavy-duty twin tube construction
- 5/8 inch hardened double chrome rod
- Internal rebound bumper and oversize piston head
- Red polyurethane bushings with a red boot
- Expanded fluid reservoir for steadier performance with less foaming
- Heavy mileage white paint with minimum 240-salt protection
Front or rear placement
Some shocks are designed for both the front and rear of a vehicle, but the mounting points, length and valving still need to suit the axle. Before swapping positions, compare the shock’s mounting eyes and stud locations with the brackets on your vehicle. A shock that fits the bracket can still sit at the wrong angle if it was built for the other end.
On a lifted truck, the rear shocks control axle movement and load. Rear travel affects how the back end squats under acceleration and rebounds over bumps. When replacing rear shocks, keep the same mounting position on both sides so the rear end behaves evenly.
- Match the shock to the axle it will control
- Check bushings and mounts for wear before installing
- Keep left and right units the same model
- Tighten the mounting hardware again after the first drive
Specifications
| Brand | Skyjacker |
|---|---|
| Series | Hydro Series |
| Part number | H7058 |
| UPC | 803696139784 |
| Mounting position | Rear or front, depending on setup |
| Lift range | 3.5 to 5 in |
| Damping | Hydraulic |
| Body | Heavy-duty twin tube |
| Valving | Multi-stage velocity sensitive |
| Piston rod | 5/8 inch diameter, hardened double chrome |
| Bushings | Red polyurethane |
| Boot | Red |
| Finish | Heavy mileage white paint, minimum 240-salt protection |
Vehicle fitment
Chevrolet Blazer, K10, K20, K30 and K5 Blazer trucks from 1973 to 1986, along with V10, V20 and V30 trucks and Suburban models from 1987 and later. It also fits Dodge, Ford, GMC, Jeep, Mazda, Mitsubishi, Nissan and Toyota models, including Ford Bronco, F-150 and Ranger, Jeep CJ and Grand Cherokee ZJ, Ram 2500 and 3500 trucks from 2003 to 2010 and 2011 to 2012, and Toyota T100 models.
Confirm fit for your vehicle’s year, model and trim before ordering, including any Wrangler YJ application.
Installation notes
Match your lift height to the setup you are building, and use a 4 inch lift for CJ applications. Confirm front or rear mounting for your vehicle, and support the vehicle on jack stands while installing the shock.
What’s included
One shock absorber with red polyurethane bushings and a red boot.
Not included: the suspension lift kit needed for the 3.5 to 5 in lift range.









