Overview
The Skyjacker 9800 is a Silver 9000 front steering stabilizer cylinder with a black boot, sold as a replacement cylinder with no hardware. It fits a long run of GM, Ford, Dodge, Jeep, International and Plymouth trucks and SUVs, mostly older models from before 2000.
Use the fitment section below to check your model year, since the list groups many trim levels under each year range.
Key features
- Single front steering stabilizer cylinder in the Hydro Series design
- Black shock boot and silver finish
- Fits a wide range of older GM, Ford, Dodge and Jeep trucks
- Replacement cylinder; no hardware included
Restoring an older truck’s steering
Older trucks in this range often carry decades of wear in the steering linkage, including worn pitman arms, drag links and tie rod ends. A new stabilizer restores control best when those joints are tight, so inspect them before assuming the damper is the only problem. Rust on the frame mounts is also common on trucks from this era and should be addressed before installation.
Many owners of pre-2000 trucks keep the original brackets, so check their condition and fit before reusing them with a new cylinder. Clean the mounting surfaces, use fresh fasteners, and confirm the cylinder has full travel. Road and trail use will show any shortcomings quickly, so recheck the setup after the first few drives.
- Inspect pitman arm and drag link for play
- Replace rusted or stretched mounting fasteners
Specifications
| Brand | Skyjacker |
|---|---|
| Part number | 9800 |
| UPC | 803696213392 |
| Series | Hydro Series |
| Type | Stabilizer only |
| Configuration | Single |
| Position | Front |
| Boot | Black shock boot |
| Finish | Silver |
| Brackets | Not included |
| Hardware | None included |
Vehicle fitment
It fits Chevrolet Blazer 1969 to 1974 and 1989 to 1994; C10, C20 and C30 1967 to 1986; K10 1961 to 1973; K20 1961 to 1972; K30 1968 to 1972 and 1977 to 1986; K5 Blazer 1975 to 1984; R10, R20 and R30 1987 to 1988; K1500 and K2500 1988 to 1998; Tahoe 1995 to 1999; Dodge Ramcharger 1974 to 1993; Ford Bronco 1966 to 1996 and Bronco II 1986 to 1990; Ford F-100 1970 to 1983, F-150 1975 to 1996, F-250 1980 to 1998 and F-350 1980 to 1997; GMC C, K and R series trucks and Suburbans from 1967 to 1998; International Scout II 1971 to 1980; Jeep Gladiator 1963 to 1967; and Plymouth Trailduster 1974 to 1981.
Most listed models end before 2000, so newer generations and all Wrangler models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The cylinder comes without brackets or hardware, so confirm the mounting points on your truck and any brackets you plan to reuse before starting work.
What’s included
One replacement stabilizer cylinder with a black boot.
Not included: brackets and hardware.









