Overview
The Rugged Ridge 11031.01 X-Clamp in Black is a universal tube mount for lights, cameras, antennas and similar accessories on round tubing from 1.25 to 2 inches in diameter. Because the clamp is not built for a single vehicle, it can go on any tube in that size range, whatever vehicle carries the tube.
Each clamp is rotated to suit the tube diameter, the bracket is pivoted to your chosen position, and then the accessory is attached. The design is patent pending, with patent numbers 9,610,888, 9,145,084 and D773,110.
Key features
- Clamps to round tubing from 1.25 to 2 inches in diameter
- Pivotal Fit Technology: rotate the clamp to the tube size, then pivot the bracket
- Holds lights, cameras, antennas and other accessories
- Black finish to match the wider X-Clamp range
- Universal fit, so it is not tied to one vehicle
Small tube mounts on trails
Smaller tubing in the 1.25 to 2 inch range suits compact accessories such as work lights, small cameras and slim antennas. Heavier gear puts more leverage on a small tube, so the clamp can rotate under load if fasteners are not seated well.
Grip depends on the jaws meeting the tube evenly. Keep the contact surfaces clean and check that the clamp sits square rather than at a tilt. Tubes with a thin wall can flex, so avoid overtightening.
When choosing an accessory, weigh it against the clamp size and the tube it will sit on. A light much heavier than the mount was designed for can strain the bracket pivot and the fasteners over time. Small tube mounts reward a conservative load.
- Check jaw contact
- Watch for flex on thin tubes
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11031.01 |
| UPC | 804314259631 |
| Finish | Black |
| Tube diameter | 1.25 to 2 inches |
| Fitment | Universal fit |
| Patents | 9,610,888; 9,145,084; D773,110 (patent pending system) |
Vehicle fitment
The X-Clamp is universal fit and is not a vehicle-specific bracket. Fit depends on the mounting tube, which must measure between 1.25 and 2 inches in diameter, and a 1.25 inch tube and a 2 inch tube both fall inside that range.
No vehicle model is excluded by the fitment, but tubing outside the 1.25 to 2 inch range will not take this clamp. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rotate the clamp until it matches your tube diameter, pivot the bracket to the angle you need, then attach the accessory. Tighten every fastener before driving, because a light or camera that shifts on rough trail can lose its aim or come loose. Wire any light to a fused circuit and follow local road-use rules for lighting placement.
What’s included
The X-Clamp is the mounting piece, sold in black. Check the package contents against your installation before starting.
Not included: the light, camera, antenna or other accessory you mount to the clamp.












