Overview
The Rigid Industries 465683 is a bumper mount kit for the 2016-2017 Toyota Tacoma that carries a 30 inch SR-Series PRO Hybrid Combo light bar on the front bumper. The kit is built from laser cut 304 stainless steel and comes with the wiring harness and installation hardware needed to mount the light bar.
The brackets have a scratch resistant powder coat finish and are UV resistant. The mounts are light weight. Because the factory plastic bumper must be partly cut, professional installation is required.
Key features
- Laser cut 304 stainless steel mounting brackets
- Scratch resistant powder coat finish
- UV resistant construction
- Light weight design
- Includes one 30 inch SR-Series PRO Hybrid Combo light bar
- Includes wiring harness and installation hardware
- Bumper mounted light bar placement
Wiring and road use
A bumper-mounted light bar carries a fair amount of current, so the wiring should be fused and routed with a relay rather than run straight from the battery to the switch. Keep the harness away from moving parts, hot exhaust and sharp edges in the bumper area. Good routing protects the light bar when the front end flexes on rough ground.
Light bars on a front bumper add weight and wind load at speed, so mount them where the hardware can carry that load without flexing the plastic. Check the mounts after rough trails, and confirm local rules for auxiliary lights before using them on public roads. Keeping the lens clean helps the light bar perform as intended.
- Use fused relay wiring with a dedicated switch
- Check bracket bolts after rough trails
- Clean the lens regularly for full output
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 465683 |
| UPC | 849774025297 |
| Bracket material | 304 stainless steel, laser cut |
| Finish | Scratch resistant powder coat |
| Included light bar | 30 inch SR-Series PRO Hybrid Combo |
| Mounting | Bumper mounted |
Vehicle fitment
Fitment is for the 2016-2017 Toyota Tacoma in Limited, SR, SR5, TRD Off-Road, TRD Pro and TRD Sport trims.
Tacoma model years outside 2016-2017 do not fit this kit. Check your year, model and trim against the fitment before buying.
Installation notes
Professional installation is required because some cutting of the factory plastic bumper is needed. Run the light bar through the included wiring harness, and use fused relay wiring with the light bar, following local rules for road use of auxiliary lights.
What’s included
The kit includes one set of bumper mounts, one 30 inch SR-Series PRO Hybrid Combo light bar, the wiring harness and the installation hardware.









