Overview
The Rugged Ridge 18760.23 is a 37 tooth short shaft speedometer drive gear for electrically driven speedometers on Jeep vehicles, including 93-01 Jeep Cherokee, 93-98 Grand Cherokee and 93-06 Wrangler models.
Speedometer gears with different tooth counts change how the speedometer reads. Match the 37 tooth count to the gear you are replacing before installing.
Key features
- 37 tooth count
- Short shaft design for electrically driven speedometers
- Direct replacement for the original gear.
- No drilling required for installation
- Rugged Ridge part number 18760.23
Why tooth count matters
The speedometer converts gear rotation into a speed reading, so the tooth count must match what the vehicle was calibrated for. A different count makes the gauge read high or low even when the cable and sensor work correctly. Short shaft gears like this one sit close to the transmission, which is why shaft length is often compared alongside tooth count before fitting.
Before swapping, count the teeth on the original gear and set the old part aside until the new one is running. Keep the speedometer wiring or cable connection clean and seated, since poor contact can mimic a gear fault. After installation, check the reading against a known speed on a safe road to confirm the gear is correct.
- Count the teeth on the original gear before ordering
- Inspect the mounting bore for debris
- Test the reading after the first drive
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 18760.23 |
| UPC | 804314254650 |
| Gear teeth | 37 |
| Shaft type | Short |
| Speedometer type | Electrically driven |
Vehicle fitment
It fits electrically driven speedometers on 93-01 Jeep Cherokee (XJ), 93-98 Jeep Grand Cherokee (ZJ) and 93-06 Jeep Wrangler (YJ and TJ) models.
Cable-driven speedometers and years outside 93-06 are not covered by this gear. Match your vehicle’s year, model and trim to these ranges before ordering.
Installation notes
No drilling is required for installation.
What’s included
Check the package contents against your installation before starting.












