Overview
The 17235.11 is a 3-position rocker switch for dual-function LED lighting. It is a universal fit, so it is not tied to a particular vehicle. It lets one switch power two separate circuits: the running lamps, and then the high-output driving lamps when you switch over.
The switch works as the companion to Rugged Ridge Dual Beam LED Lights 15209.30 and 15209.31. It is illuminated when engaged and is rated for 21 amps at 14 VDC.
Key features
- Dual output design powers two separate circuits from one switch
- Switches between running lamps and high-output driving lamps
- Illuminated when engaged
- Rated for 21 amps at 14 VDC
- Designed to complement Rugged Ridge Dual Beam LED Lights 15209.30 and 15209.31
- Universal fitment listed
Running and driving lamp wiring
Dual output switches simplify a dual-lamp setup, but the two outputs share one switch body and one set of contacts. Keep both circuits fused and avoid combining a heavy driving lamp load with the running lamp circuit on the same fuse.
The companion lights matter for the layout. Plan the lamp mounting and wire routing before connecting the switch, so the running lamps and driving lamps can be separated cleanly. Route the wiring away from sharp edges and heat sources, and secure it with clips.
Driving lamps must follow local road-use rules, so check them before you use the switch to change between running and driving lamps on a public road. A relay for the driving lamp circuit is a common addition that protects the switch from heavier current.
- Separate fuses for each output
- Relay for driving lamp load
- Route wiring away from heat
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 17235.11 |
| UPC | 804314295325 |
| Type | 3-position rocker switch |
| Output | Dual output, two separate circuits |
| Rating | 21 amps at 14 VDC |
| Illumination | Illuminated when engaged |
| Fitment | Universal |
Vehicle fitment
It is a universal fit, so it is not written for a specific year, make or model. It is an electrical switch for lighting circuits, and its suitability depends on the lamps and wiring it is connected to.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Wire the switch so the two outputs feed the running lamp and driving lamp circuits as your lamp instructions describe. Because the switch is rated for 21 amps, keep the combined load of the connected lamps within that rating. Driving lamps are subject to local road-use rules, and a fused circuit is a sensible addition to the wiring.
What’s included
The switch itself is included. Hardware, wiring and lamps are not included.
Not included: the Rugged Ridge Dual Beam LED Lights 15209.30 and 15209.31, which are a separate purchase.














