Overview
The Rugged Ridge Body Armor Rocker Guards in Black Plastic, part number 11651.06, are rocker guards for 2-door 2007–2018 Jeep Wrangler (JK) models. Rugged Ridge builds each guard from UV treated thermoplastic with a black diamond plate look, adding an off-road appearance to the lower body of the Jeep.
Each guard mounts with 3M automotive grade tape and bolts, which Rugged Ridge describes as an ultra strong attachment. The company also suggests the guards can cover a scratch or dent on the paint: fill the damaged area with touch-up paint to help prevent rust, then install the guard over it.
Key features
- Black diamond plate look thermoplastic construction
- UV treated thermoplastic material
- 3M automotive grade tape and bolt attachment
- Designed for 2-door models, 3 3/4 inch wide
- Installs with no cutting or drilling
- Can be installed over a repaired scratch or dent after touch-up paint
Preparing the body for guards
Guards that cover a scratch or dent work best when the repair is sound. Clean the damaged area, sand any rough edges lightly, and apply touch-up paint in thin coats so the surface is level under the guard. Allow the paint to cure before pressing the guard into place, since uncured paint can move under the tape.
Because the guards use 3M automotive grade tape and bolts, the surface must stay clean for the bond to hold. Check the bolt holes for corrosion and replace any fasteners that are rusted or stretched. Before drilling anything near the front, confirm the under hood route is clear, since the front guard may need some drilling. Inspect the guards after rough trails for lifting edges, and tighten the bolts when you see movement.
- Sand rough paint edges before touch-up
- Let touch-up paint cure fully before mounting
- Inspect bolts after the first few off-road outings
Specifications
| Brand | Rugged Ridge |
|---|---|
| Part number | 11651.06 |
| UPC | 804314172169 |
| Finish | Black Plastic |
| Type | Plastic guard |
| Material | Diamond plate look UV treated thermoplastic |
| Width | 3 3/4 inch |
| Body style | 2-door models |
| Attachment | 3M automotive grade tape and bolts |
| Installation type | No cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct-fit guard for 2007–2018 Jeep Wrangler (JK) 2-door models, including the 70th Anniversary, 75th Anniversary, Rubicon, Sahara, Sport, Sport S and X trims. It is not a universal part.
This fitment does not cover the 1997–2002 Jeep Wrangler (TJ) or the 2004–2006 Wrangler (LJ), which are other generations. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The front guard may need some under hood drilling, so check that step before you start. Use touch-up paint on any scratch or dent before the guard goes on.
What’s included
Compare the included tape and bolts against the installation steps before starting.
Not included: Touch-up paint for scratch or dent repairs is not part of the kit.









