Overview
The Rancho RS55144 is a rear RS5000X Series shock absorber for the 1984 to 1985 Toyota 4Runner (DLX, SR5) and the 1988 to 1989 Toyota Land Cruiser (Base). Its rebound valving is patented and its compression phase is advanced, aimed at steadier handling on and off the pavement.
It is a direct fit design for the rear position with a lift rating of w/0 – 2 in. Lift. Its compressed length is 14.19, extended length 22.34 and travel length 8.15, with no unit given.
Key features
- Patented rebound valving system and advanced compression phase
- Direct fit design for the rear position
- Lift height rated w/0 – 2 in. Lift
- Compressed, extended and travel lengths listed in the specifications
- Valving designed to improve on- and off-road handling
Why shock length matters
Shock length decides whether a new unit will fit the mounting points and the suspension travel. A shock that is too long can bind at full droop, while one that is too short can strike its bump stop before the suspension reaches its limit. Measuring the old unit from eye to eye, and checking its extended and compressed lengths, is the simplest way to confirm a match before the truck is lifted.
Rear shocks on older Toyota trucks and SUVs often wear through their seals and bushings rather than the body itself. Look for oil on the outside of the tube, a clunk when the rear axle changes direction, or a bouncy ride after bumps. Clean the mounting surfaces before reinstalling, since rust on the eye can loosen a bolt over time.
- Measure eye-to-eye before ordering
- Compare extended and compressed lengths
- Check for oil on the tube
- Clean mounting surfaces when reinstalling
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS55144 |
| UPC | 39703008006 |
| Series | RS5000X Series (per title) |
| Position | Rear |
| Fitment type | Direct Fit |
| Lift height | w/0 – 2 in. Lift |
| Compressed length | 14.19 (unit not stated) |
| Extended length | 22.34 (unit not stated) |
| Travel length | 8.15 (unit not stated) |
Vehicle fitment
The manufacturer fitment list covers the 1984 to 1985 Toyota 4Runner in DLX and SR5 trims and the 1988 to 1989 Toyota Land Cruiser in Base trim.
Other 4Runner years and other Land Cruiser years are not on this list. Check your exact year and trim before fitting.
Installation notes
Measure the shock being removed and compare its compressed, extended and travel lengths with the figures above before installing. The figures carry no unit, so take the old shock’s measurements the same way.
What’s included
The package is a single rear shock absorber. Check the mounting brackets and hardware against your installation before starting.












