Overview
The Rock Hard 4×4 Parts RH-5046 is a Patriot Series full-width front bumper for the 2007–2016 Jeep Wrangler JK, in 2-door and 4-door versions. It is made from 1/4 inch aluminum plate with a textured black powdercoat finish, weighing 37 pounds versus 137 pounds for the steel version.
The bumper tapers down and back to protect the factory front cross frame and the sway-bar disconnect unit, and it accepts factory fog lights. Rock Hard 4×4 describes its Direct-to-Frame (DTF) mounting to the frame horns and says winches sit on top of the frame rails with no trimming. Two light tabs are provided for aftermarket lights, and the factory bumper hardware is used for installation.
This full-width design suits trails where tire covering and fender protection matter. Compared with the narrower grille-width bumper, it covers more of the front end. The steel version weighs 137 pounds, so the aluminum construction saves a large amount of weight.
Key features
- 1/4 inch aluminum plate
- Total weight of 37 pounds versus 137 pounds for the steel version
- Tapers down and back to protect the factory front cross frame and sway-bar disconnect unit
- Direct-to-Frame (DTF) mounting to the frame horns
- Winch on top of the frame rails, pre-drilled mounting holes
- Accepts factory fog lights
- 2 light tabs for aftermarket lights
- Laser cut Hi-Lift jack recovery points and double welded shackle tabs
Before you buy
Front bumpers affect how a Wrangler handles tight terrain and how well the front end holds up to contact with rocks and brush. A heavier steel unit adds weight at the front of the vehicle, so a lighter aluminum bumper can help keep the steering and suspension closer to the balance of the factory setup. Before buying, look at the winch you plan to run, the recovery points you already use, and any sensor or fog light wiring that sits behind the bumper.
Bumpers are often replaced together with a few related parts. Recovery straps, a rated winch, and upgraded D-rings or shackles are common additions, and the frame mounts should be inspected before installation. After the first few trail runs, re-check fasteners and look for cracked welds or loose brackets. Touch up any deep scratches in the powdercoat to slow corrosion on exposed metal.
Specifications
| Brand | Rock Hard 4×4 Parts |
|---|---|
| Part number | RH-5046 |
| UPC | 700006993331 |
| Series | Patriot |
| Position | Front |
| Width | Full |
| Material | Aluminum, 1/4 inch plate |
| Finish | Textured black powder coat |
| Weight | 37 pounds (steel version: 137 pounds) |
| Winch mount | Included, pre-drilled |
| Light mounts | Included (2 light tabs) |
| D-ring mount | Included |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2007–2016 Jeep Wrangler JK in 2-door and 4-door versions.
This bumper is designed for the JK generation, so confirm the fit against your vehicle’s year, model and trim before ordering.
Installation notes
Installation uses the factory bumper hardware and the Direct-to-Frame mounting to the frame horns. The winch bolts to pre-drilled holes on top of the frame rails.
What’s included
- Full-width front bumper
- Winch mounting holes
- D-ring shackle mounts
- Two light tabs
Not included: Winch, lights and shackles.
























