Overview
The Rigid Industries 40199 is an 8′ wiring harness that connects a single LED light to a 12V electrical system. It has battery terminals on one end and a Deutsch connector on the other that plugs into the light.
It works with SR-M, SR-M2, SR-Q and SR-Q2 Rigid Industries LED lights. It is universal fit, so the light model determines compatibility rather than the vehicle.
Key features
- Connects one LED light to a 12V system
- Battery terminals on the power end
- Deutsch connector on the light end
- Inline fuse holder
- 12V relay and waterproof switch
Wiring and fuse protection
The fuse in the positive lead protects the wiring if a short occurs, so it should sit close to the battery terminal rather than near the light. Keep the fuse holder dry and mounted where it can be reached for inspection. Ground connections matter as much as the positive lead, so clean the battery post contact and tighten it firmly.
A relay lets a small switch control a larger load, which reduces the strain on the switch. Waterproof switches work best when mounted in a dash panel or bracket where water runs away from the contacts. Route the harness away from belts, pedals and sharp panel edges, and tie it off along the existing body wiring.
- Inspect the fuse holder for corrosion each season
- Check that the relay clicks when the switch is operated
- Keep the switch cover closed in wet weather
Specifications
| Brand | Rigid Industries |
|---|---|
| Part number | 40199 |
| UPC | 815711013030 |
| Length | 8′ |
| Lights supported | Single LED light |
| Compatible lights | SR-M, SR-M2, SR-Q, SR-Q2 |
| Included components | Inline fuse holder, 12V relay, waterproof switch |
Vehicle fitment
This harness is universal fit and is not vehicle-specific. It is matched to the listed Rigid Industries LED light models.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Connect the battery terminals with the correct polarity and keep the inline fuse in the positive lead. Auxiliary lights on a 12V circuit need a fused, relay-switched feed.
What’s included
The harness includes battery terminals, a Deutsch connector, an inline fuse holder, a 12V relay and a waterproof switch.
Not included: the LED light.









