Overview
The Rancho RS5308 is a rear gas charged RS5000 Series shock absorber for the 2006–2010 Hummer H3, the model on its manufacturer fitment list. It is a direct-fit replacement shock built with a 1 3/8-in. (35mm) piston and a red protective boot.
The RS5000 family suits light trucks and utility vehicles, and it works on both stock and lifted vehicles. This RS5308 uses ten-stage velocity sensitive valving and a 5/8-in. (16mm) piston rod, matching the internal design used across the RS5000 Series.
Key features
- Rear position gas charged shock absorber
- Ten-stage velocity sensitive valving
- 1 3/8-in. (35mm) diameter piston
- 5/8-in. (16mm) diameter piston rod
- Red protective boot included
- Lift/Drop rating of w/0 in.
Before you buy
A rear shock absorber controls how quickly the rear spring compresses and rebounds, so it affects braking dive, cornering body roll and how the truck settles after a bump. Replacing a worn unit restores that control, especially on uneven trail surfaces where the damper does the most work.
Before ordering, compare the vehicle’s year, model and trim with your own truck, and measure its current rear height so the rated range matches your setup. If the truck carries aftermarket springs or a lift, confirm the shock length suits that ride height. Shocks wear gradually, so inspect them at each service rather than waiting for a failure.
- Look for oil residue on the shock body
- Note any clunking or continued bouncing after bumps
- Check for uneven rear tire wear
- Replace shocks in pairs on the same axle
Specifications
| Brand | Rancho |
|---|---|
| Part number | RS5308 |
| UPC | 39703001212 |
| Series | RS5000 Series |
| Position | Rear |
| Fitment type | Direct fit |
| Charge type | Gas charged |
| Valving | Ten-stage velocity sensitive |
| Piston diameter | 1 3/8-in. (35mm) |
| Piston rod diameter | 5/8-in. (16mm) |
| Lift rating | w/0 in. Lift/Drop |
| Boot | Red protective boot |
| Unit of count | Each |
Vehicle fitment
The manufacturer fitment list for the RS5308 names one vehicle: the 2006–2010 Hummer H3 in the Alpha, Base, Championship Series and X trims. The rear position applies to this H3 entry.
Hummer H2 and other GM trucks are not on this list, and H3 model years outside 2006–2010 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the w/0 in. Lift/Drop rating against your H3’s current height before you install the shock. Rear shocks carry spring load, so secure the vehicle before loosening the original mounts.
What’s included
One rear shock absorber fitted with a red boot. Check the package contents against your installation, including any mounting hardware, before starting.









