Overview
The Putco 230004A is an LED light bulb resistor kit for turn signal circuits. It addresses LED-related turn signal problems such as hyper flashing and burnt-out bulb indicators, and its 6 Ohm 50 Watt resistors are designed for most import and domestic vehicles.
Hyper flashing is a fast turn signal flash that can appear when LED bulbs draw less current than the originals. The compact design is intended to make installation easier.
Key features
- Addresses hyper flashing
- Addresses burnt-out bulb indicators
- 6 Ohm, 50 Watt resistors
- Compact design
- Universal fit for most import and domestic vehicles
Before you install
Turn signal flashers were built around the current draw of incandescent bulbs. LED bulbs draw much less current, so the flasher can run too fast or the dash indicator can stop working. A resistor kit adds load to the circuit so the system behaves the way it did with the original bulbs. Because resistors dissipate heat, mount them where airflow is good and away from wiring insulation and plastic trim.
Before buying, look at what the rest of the lighting system needs. Some vehicles use an electronic flasher that already handles LED loads, and in that case resistors may not be needed. Replacing bulbs in pairs keeps both sides of the vehicle matched, and checking the connectors for heat damage after the first drive helps catch problems early.
- Check both front and rear signal circuits
- Mount resistors away from heat-sensitive parts
- Inspect connectors after the first drive
- Replace bulbs in pairs for even flashing
Specifications
| Brand | Putco |
|---|---|
| Part number | 230004A |
| UPC | 10536240108 |
| Resistance | 6 Ohm |
| Power rating | 50 Watt |
| Fitment | Universal fit |
Vehicle fitment
It is a universal fit for most import and domestic vehicles. No specific year, make or model applies, so confirm that the 6 Ohm, 50 Watt rating suits your turn signal circuit.
Installation notes
Resistor kits like this one are installed on the turn signal circuit. Disconnect the battery before working on any wiring, and check local rules on lighting modifications.
What’s included
Check the package contents against your installation before starting.









