Overview
The Pro Comp Suspension 63013 is a reservoir mounting kit for holding a shock reservoir to a 1.5 inch tube, such as a shock hoop. It steps from a 2 inch shock to the 1.5 inch tube.
Key features
- Mounts one shock reservoir to a 1.5 inch tube
- Steps from 2 inch to 1.5 inch
- Urethane blocks
- Stainless steel clamps
Reservoir routing and clearance
A remote reservoir needs room to sit where it can be checked and where the hose does not kink. Mounting it on a shock hoop keeps it away from the tire and off the frame, but the hose route has to allow full suspension travel. Think about where the reservoir will sit when the suspension compresses and extends, not only at rest.
Routing a hose along a moving part invites rubbing, so use the mounting points to keep it clear of edges and heat sources. Check the fittings after the first few drives, and look for fresh wet spots or loose clamps. A small adjustment early prevents a larger repair on a trail later.
If the reservoir sits lower or higher than before, consider how the shock angle changes, since the hose length may need adjusting. Plan the layout on the bench before fitting it to the truck.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 63013 |
| UPC | 614901021745 |
| Tube size | 1.5 in |
| Shock size | 2 in |
| Blocks | Urethane (2) |
| Clamps | Stainless steel (2) |
| Sold as | Pair |
Vehicle fitment
It is a mount for one specific shock and hoop size, so measure the shock and the hoop tube before ordering.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Two urethane blocks and two stainless steel clamps.










