Select your vehicle

Power Stop Brake Pad Wear Sensor – SW-1524

Power Stop

Out of stock
Buy on Amazon

See similar parts on Amazon

Price and availability as of Nov 18, 2026 2:20 AM MST, from Amazon.com, and subject to change. The Amazon listing has the current details.

Check out with your Amazon account. Amazon handles delivery and returns.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Front electronic brake pad wear sensor
  • Fits 2005-2009 Land Rover LR3 and 2010-2016 LR4
  • Super conductive electrodes
  • Snap-in installation

Description

Overview

The Power Stop SW-1524 is a front brake pad wear sensor for the 2005-2009 Land Rover LR3 and the 2010-2016 Land Rover LR4. It is part of Power Stop’s Euro-Stop program.

The sensor is built to withstand high temperatures, up to 500 degrees, and to keep dependable electrode contact. Replacing the sensor with the pads is common practice, since the sensor sees the same heat and wear as the pad.

Key features

  • Front position
  • Withstands heat up to 500 degrees
  • Super conductive electrodes
  • Snap-in installation
  • Recommended with every brake job

Sensor replacement and wiring

Front pad wear sensors on Land Rover models sit in the inner pad, where they can contact the rotor as the friction material wears. Because the sensor wears in the same way as the pad, most technicians fit a new one whenever the pads are replaced, which keeps the warning accurate for the new pad material. Heat from repeated braking can wear the sensor tip over time, so a sensor that has seen heavy use should not be reused.

Before installing, check the sensor lead for cuts, and route it so it stays clear of the rotor, the hub and the steering knuckle. Snap the sensor into the pad cavity with the lead facing the correct direction. After the wheel is refitted, drive gently for a few miles and watch the dash for any warning that appears.

  • Replace the pad and sensor on the same side together

Specifications

Brand Power Stop
Part number SW-1524
Part type Electronic brake pad wear sensor
Position Front
Heat resistance Up to 500 degrees
Fit type Direct fit

Vehicle fitment

It fits the 2005-2009 Land Rover LR3 and the 2010-2016 Land Rover LR4.

Range Rover Sport models use the rear SW-1525 listing instead. Confirm your vehicle’s year, model and trim before ordering.

Fitment

VehicleYearsTrims
Land Rover LR32005–2009Base, HSE, HSE Lux, SE
Land Rover LR42010–2016Base, HSE, HSE Lux, V8

Use “Select your vehicle” at the top of the page to check this part against your vehicle.

Questions & Answers

Does the SW-1524 fit a Land Rover LR4?

Yes. It fits the 2010-2016 LR4 and the 2005-2009 LR3 at the front brake position. Confirm your vehicle's year, model and trim fit before ordering.

Is the SW-1524 for the front axle?

Yes. It is the front position sensor for the LR3 and LR4. The rear sensor for those vehicles is a separate part number, SW-1525, so check the position before ordering.

What temperature can it handle?

Up to 500 degrees. The sensor is built to withstand that heat and uses super conductive electrodes, which are designed to keep reliable contact in the sensor circuit. It snaps in place during installation.

Can the SW-1524 be fitted without replacing the pads?

It is possible, but the sensor is usually changed with the pads so the warning reflects the new pad thickness. If the sensor is reused, inspect the tip for damage and check the wiring first. A worn or damaged sensor can cause a false warning or none at all.

Ready to order?

Order this part on Amazon and check out with your Amazon account. Amazon handles delivery and returns.

Buy on Amazon