Overview
The EBC Brakes EFA072 is a front brake wear lead sensor kit for the 2007–2015 Audi Q7, the 2005–2006 and 2008–2010 Porsche Cayenne and the 2004–2017 Volkswagen Touareg. It is a replacement wear sensor for the brake pads.
EBC says brake wear sensors help protect your rotors from going metal to metal, which can cause severe damage. The sensor is a direct fit part for the front position.
Key features
- Brake wear lead sensor kit
- Front position
- Helps protect rotors from metal to metal contact
- Direct fit replacement
How wear sensors signal pad wear
A wear sensor is a thin metal tab mounted in the pad. As the friction material thins, the tab contacts the rotor and creates a squeal that warns the driver before the backing plate touches metal. Some vehicles use an electrical lead sensor that completes a warning circuit to the dash instead, so the sensor style should match what the vehicle uses.
Because sensors are usually left in place when pads are replaced, they are normally changed along with the pads. Replacing a sensor on worn pads does not restore pad life, and a sensor that has been bent or pinched in the wheel well may read incorrectly. Inspect the lead for chafing at each brake service, and watch for a dash warning that does not clear.
- Replace the sensor whenever the pads are replaced
- Look for chafed or pinched lead wiring
- Watch for a warning light that stays on after a pad change
Specifications
| Brand | EBC Brakes |
|---|---|
| Product type | Brake wear lead sensor kit |
| Position | Front |
| Fit type | Direct fit |
| Category | ABS brake components |
| Manufacturer part code | EBCEFA072 |
| Item number | EFA072 |
Vehicle fitment
It fits the 2007–2015 Audi Q7 in Base, Premium, Premium Plus, Prestige, TDI, TDI Premium, TDI Premium Plus and TDI Prestige trims; the 2005–2006 and 2008–2010 Porsche Cayenne in Base, GTS, S, Turbo and Turbo S trims; and the 2004–2017 Volkswagen Touareg in Base, TDI, TDI Executive, TDI Lux, TDI R-Line, TDI Sport, V6, V6 Executive, V6 Lux, V6 R-Line, V6 Sport, V6 Wolfsburg, V8, VR6 and X trims.
Check the package contents against your installation before starting, and match the sensor to the brake pad set fitted to your vehicle.
The stored list covers only the Audi Q7, Porsche Cayenne and Volkswagen Touareg model years shown. Other years, and other Audi, Porsche and Volkswagen models, are not covered, and rear sensors are a different part. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Replace wear sensors as a set with new pads on the same axle, make sure the sensor lead is routed away from rotating parts and heat, and clear any warning indicator as the vehicle manufacturer directs. Brake components are safety-critical, so professional installation is recommended. Keep friction surfaces and rotors free of oil and grease, and test the brakes at low speed in a safe area before normal driving. Re-check the work after the first miles of driving.









