Overview
The Poison Spyder Fire Extinguisher Holder, part number 57-62-110, mounts a fire extinguisher to a roll bar with Velcro straps. It is a universal fit, not built for one vehicle, so the roll bar tube size and padding decide whether the straps suit a given setup.
The straps are sized for padded roll bars. On bare, unpadded tubes the strap ends run long, and the extra length can be tucked under the strap or cut off. For a bare tube, Poison Spyder recommends one with an outside diameter of 1.75 inches or larger.
Key features
- Velcro straps hold the holder to a roll bar
- Straps sized for padded roll bars
- Bare tubes of 1.75 inches outside diameter or larger recommended
- Excess strap length on bare tubes can be tucked in or cut off
- Nylon webbing ends can be sealed with a lighter after cutting
Mounting and upkeep
A fire extinguisher holder is only as secure as the surface it grips. On a roll bar, the goal is a spot that keeps the bottle upright, clear of seat belts and reachable from the driver’s seat without twisting. Mount it low enough that the bottle will not fly up in a rollover, but high enough that dirt and water do not collect around the base. Check that the bottle’s bracket sits flat against the tube rather than rocking on the curve.
Once the spot is chosen, test the holder by tugging it in several directions before the first trip. Velcro straps loosen with vibration and dust, so inspect them after the first few runs and again before each outing. Replace any strap with frayed stitching or a cracked hook-side edge. Keep the extinguisher’s pressure gauge in the green zone, and recharge or replace the bottle after any discharge or if the gauge drops.
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 57-62-110 |
| UPC | 614901732078 |
| Mounting | Velcro straps around the roll bar |
| Recommended bare tube | 1.75 in outside diameter or larger |
Vehicle fitment
It is a universal fit and is not matched to a specific year, make or model. Fit depends on the roll bar: padded tubes suit the straps as sized, and bare tubes need the excess strap tucked or trimmed.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Wrap the straps around the roll bar, then tuck or trim any excess on bare tubes. A trimmed nylon strap end can be sealed with a lighter so it does not fray. Check the straps before each trip, because a loose extinguisher can injure occupants in a collision.
What’s included
The holder with its Velcro straps. Not included: the fire extinguisher.
















