Overview
The Poison Spyder 13-02-050 is a DeFender front fender in bare steel with a negative flare. Poison Spyder fabricates its DeFenders entirely from CNC laser cut, precision brake-formed 3/16-inch heavy duty P&O steel plate. The negative flare is the version the company builds for the most tire clearance, full articulation and tight trails.
The fender has an underside return, a lip along its bottom edge. The return keeps the fender from cutting into a fully stuffed tire and adds strength to the outer edge, which is the part most likely to contact rocks, canyon walls and trees. The fender ships unpainted and is ready for finish.
The negative flare tapers inward to closely hug the edge of the hood. The narrower edge leaves room to mount the hood latch and a steel rub rail that protects the side of the hood. The design suits owners who want a low center of gravity with big tires and minimal lift. It allows full suspension articulation while keeping an armored, non-highline fender.
DeFenders are designed to work with the Jeep’s factory inner fenders. That avoids the cost of replacing them and the work of removing, reinstalling or relocating the under-hood gear. Even the non-highline version gives a much larger wheel opening than stock or some competitors’ tube fenders. The back of the opening, where larger tires rub at full steering lock, sits about 2 inches further back than typical tube fenders and about 4 inches further back than the stock Jeep flares.
Key features
- Negative flare that tapers inward to hug the hood edge
- Heavy duty 3/16-inch P&O steel plate, CNC laser cut and brake-formed
- Underside return protects against fully stuffed tires and strengthens the edge
- Steel rub rail protects the side of the hood
- Designed to work with the factory inner fenders
- Mounting location for a ¾-inch LED marker
Negative flare fitment checks
A negative flare trades some outer fender width for a tighter hood fit, so the hood latch and rub rail become part of the fit check. Before final mounting, close the hood and check gaps at the front edge, the latch alignment and the rail contact. A rail that rubs the hood can scratch the paint, so trim or shim it as needed.
Tire rub at full lock depends on the steering geometry and tire width. The wheel opening is wider than the stock fender, but the front corner of the tire still moves through its arc at full turns. Check clearance with the suspension compressed and the wheel turned both ways, and keep the inner fender edges clear of the tire during testing.
- Close the hood and check the gap along the rub rail
- Test steering at both full locks with the tire fitted
- Check latch alignment before final tightening
- Recheck fasteners after the first trail day
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 13-02-050 |
| UPC | 614901723939 |
| Location | Front |
| Type | Tube fender |
| Flare | Negative flare |
| Material | 3/16-inch heavy duty P&O steel plate |
| Marker mount | ¾-inch LED marker |
| Finish | Bare steel, shipped unpainted |
| Installation type | Cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
Make sure the year, model and trim of your Jeep match before buying, since the negative flare is shaped to a specific hood and fender.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling. Because the fender is designed to use the factory inner fenders, the inner fenders stay in place. Check the hood latch and hood rub rail fit before you finish the fender.
What’s included
The DeFender front fender with the negative flare, built from 3/16-inch P&O steel plate and shipped unpainted.
Not included: the LED marker light, which mounts in the location provided, and paint or powder coating.














