Overview
The Poison Spyder 41-04-050 is a 4 inch round, 24 diode LED tail light with a red lens. It pushes into a 4-1/2 inch round hole, so it is a lighting accessory rather than a vehicle-specific part.
Poison Spyder says flush mounted LED tail lights stay out of the way of rocks and trees on the trail, and last longer and shine brighter than OEM incandescent lamps. The light installs into Poison Spyder Crusher Corners or Trail Corners made for LED taillights, into other manufacturers’ corner protectors, or into any flat panel with a 4-1/2 inch round hole.
Key features
- 24 diode LED
- Red lens, with a clear lens option
- Push-in grommet mount, flush mounted
- Clear lens units use red diodes and still flash red when lit.
- Includes the LED lamp assembly, rubber grommet and wiring pigtail harness
Mounting and trail use
A flush mounted light sits close to the panel, so there is less surface for branches, rocks and brush to catch. That makes the placement useful on a vehicle that sees tight trails, where a protruding lamp can get snagged or knocked out of alignment.
Before mounting, decide whether the red or clear lens suits the vehicle’s lighting plan. Route the pigtail away from moving parts and sharp edges, and leave a little slack so the harness does not pull on the connection when the panel flexes. Apply dielectric grease to the connections and check that the grommet seals tightly so water and mud stay out of the lamp.
- Keep the wiring harness clear of the suspension and steering
- Check the grommet seal after the first few washes or water crossings
- Recheck the light’s position after any panel or corner work
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 41-04-050 |
| UPC | 614901727975 |
| Diameter | 4 in, round |
| Hole required | 4-1/2 in round |
| Diodes | 24 |
| Lens | Red (clear available) |
| Mount | Push-in with rubber grommet |
| Sold as | Each |
Vehicle fitment
This is a lighting accessory and not a vehicle-specific part, so fit is not tied to a make, model or year. It depends on a 4-1/2 inch round hole in the panel or corner it mounts to.
Installation notes
Cut a 4-1/2 inch round hole in a flat panel, or mount the light in a Poison Spyder corner made for LED taillights, then push the light into place with the rubber grommet. Wire it with the included pigtail harness.
What’s included
The LED lamp assembly, rubber grommet and wiring pigtail harness.
Not included: a corner protector or panel to mount the light in.









