Overview
The Omix-ADA wheel bearing washer, part number 16710.02, is a replacement lock washer for the rear Dana 27 full floating axle. It is built to original specifications as a direct replacement part.
Omix-ADA backs the washer with a limited five year warranty. It is designed as a direct fit.
Key features
- Built for the rear Dana 27 axle
- Full floating axle type
- Direct OE replacement built to the original specifications
- Direct fit design
- Covered by a limited five year warranty
Installing a full floating washer
On a full floating rear axle, the wheel bearing washer and lock nut hold the axle shaft position while the wheel carries the load. The washer is a small part, but its contact faces need to be clean and flat so the nut can set the bearing correctly. Check the washer for flatness and remove any burrs before fitting it on the axle.
Torque the nut to the value in your service manual, then check for play at the wheel and for any noise during a slow turn. Replace the washer whenever you disassemble the bearing area, since reusing a bent or worn washer can allow the nut to loosen. Keep the threads clean and dry, and use lubricant only where the service manual calls for it.
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16710.02 |
| UPC | 804314068554 |
| Part type | Wheel bearing washer |
| Axle position | Rear |
| Axle type | Dana 27 |
| Axle design | Full floating |
| Warranty | Limited five year warranty |
Vehicle fitment
It is a direct fit for the rear Dana 27 axle. Make sure your vehicle’s year, model and trim suit it before buying.
Verify the axle type matches your vehicle before installing.
What’s included
The package contains the washer only.









