Overview
The Omix-Ada 12021.13 is a support bracket for a 2-bolt spare tire carrier, offered as a direct OE replacement part for the 1941–1943 Willys MB (Base). Omix-Ada says its Jeep parts and accessories are built to original specifications.
Use this bracket to support a 2-bolt spare tire carrier. Measure your carrier’s bolt spacing and the bracket footprint before installation to confirm they match.
Key features
- Support bracket for a 2-bolt spare tire carrier
- Direct OE replacement design
- It is built to original specifications.
- It fits the 1941–1943 Willys MB (Base).
Fitting a support bracket
A support bracket takes some of the carrier’s load off its mounts, which helps keep the spare steady on rough roads. On a Willys MB, the bracket and carrier work as one assembly, so both need to be inspected together. Check that the bracket sits flat against the body and that the carrier’s bolt holes line up before tightening anything.
Older body mounts can rust at the contact points, so clean those areas and look for cracks around the bolt holes. Replace worn carrier bolts and nuts when you replace the bracket, since mismatched hardware can loosen. After fitting, re-check tightness after the first few drives and whenever you carry a heavy spare.
- Check the bracket sits flat against the body
- Clean rust from the contact points
- Replace worn carrier bolts and nuts together
- Retighten fasteners after the first few drives
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12021.13 |
| UPC | 804314066116 |
| Part type | Support bracket for 2-bolt spare tire carrier |
| Application | Direct OE replacement |
Vehicle fitment
It fits the 1941–1943 Willys MB (Base) only.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Inspect the carrier and hardware on arrival, and match them to your installation first.









