Overview
Part number 18029.03 is a replacement steering box oil seal for 4 cylinder Jeep vehicles. It is a direct OE replacement built to original specifications.
It falls in the steering gear worm shaft seal category. Confirm fitment for your vehicle’s year, model and trim before ordering.
Key features
- Direct OE replacement built to original specifications by Omix-ADA
- Designed for 4 cylinder engine applications
- Direct fit replacement for Jeep steering boxes
- Backed by a limited five year warranty
Checking for steering box leaks
A steering box seal works where the shaft enters the box, holding fluid inside while the gear moves. Leaks at this location usually appear as oil on the frame rail, the inside of the wheel or a drip beneath the front of the vehicle after parking. Clean the area and watch for a fresh wet line before deciding the seal is the cause, since leaks can also come from the cover or fittings.
Replacing a seal means draining fluid, removing the shaft or pitman arm as your gear design requires, and fitting the new seal squarely with clean tools. Lubricate the lip lightly, avoid scratches on the shaft, and refill with the correct fluid for the steering box. Old seals harden over time, so a leak that returns soon after service often points to an installation problem rather than a bad part.
- Check fluid level before and after the job
- Inspect the shaft for pits or grooves
- Look for leaks after a short drive
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18029.03 |
| UPC | 804314016838 |
| Engine | 4 cylinder |
| Part type | Steering box oil seal |
| Warranty | Limited five year warranty |
Vehicle fitment
It is a direct fit for Jeep steering boxes on 4 cylinder engines. Confirm your vehicle’s year, model and trim before ordering to verify which Jeep models use it.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
The item is one steering box oil seal, part number 18029.03, sold alone.









