Overview
The Omix-Ada 17230.02 is a starter solenoid for standard or automatic transmission. It fits the 1972–1979 Jeep CJ5, the 1972–1975 Jeep CJ6 and the 1976–1979 Jeep CJ7. The solenoid is the electrical switch that engages the starter and sends current to the motor.
It is built to the original specifications as a direct OE replacement. It works with either transmission type, so transmission type does not decide the fit here.
Solenoid troubleshooting
The starter solenoid carries the switching job between the ignition and the starter motor. When the key is turned, it pushes the drive into the flywheel and closes the high-current contacts. Those contacts can burn or pit over time, which causes clicking, weak cranking or a no-start condition.
Before replacing the solenoid, check battery voltage, the battery cable ends and the ground connection, since weak power can mimic a failed solenoid. If the starter still clicks with good power, the solenoid or starter is the likely cause. When fitting a new unit, keep the wiring tight and the terminals clean.
- Clean the battery terminals and cable ends
- Test the ground strap for corrosion
- Check the solenoid wire connectors for heat damage
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17230.02 |
| UPC | 804314027230 |
| Type | Starter solenoid |
| Transmission | Standard or automatic |
Vehicle fitment
Covers the 1972–1979 CJ5 in base, Golden Eagle and Renegade versions, the 1972–1975 CJ6 base, and the 1976–1979 CJ7 in base, Golden Eagle and Renegade versions.
Other CJ years and Wrangler models fall outside the years covered. Verify your year, model and trim before ordering.









