Overview
The Omix-Ada 17229.02 is a 12-volt starter drive, the gear assembly that moves out to meet the flywheel ring gear when the starter engages. It fits the 1966 Jeep CJ3 and the 1966 to 1971 Jeep CJ5 and CJ6.
The drive is designed to match the original specifications. For CJ owners in that model span, it is the part to match against the drive on your starter.
Drive gear wear
The starter drive is the gear that slides out to engage the flywheel ring gear, then retracts once the engine starts. Its spline shaft and pinion teeth take the wear each time the starter runs. A drive that sticks or fails to retract can keep spinning after start, which causes noise and rapid wear.
When replacing the drive, clean the shaft and check the spline for burrs before fitting it. Inspect the ring gear on the flywheel for chipped teeth, since a damaged ring gear can wear a new drive quickly. Keep the spline lightly greased with a suitable starter lubricant, and avoid heavy grease that collects dirt.
- Look for dirt and dried grease on the shaft
- Check the pinion teeth for rounding or chips
- Confirm the starter bolts are tight after the install
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17229.02 |
| UPC | 804314017156 |
| Type | Starter drive |
| Voltage | 12-volt |
Vehicle fitment
It fits the 1966 Jeep CJ3, the 1966 to 1971 Jeep CJ5 and the 1966 to 1971 Jeep CJ6, all in the base version.
Other CJ years and the CJ7 fall outside the years covered here, and Wrangler models are not covered. Check your vehicle’s year, model and trim before ordering.









