Overview
It is a Dana 44 spindle washer built to original specifications as a direct OE replacement, and it fits the 1974–1983 Jeep Wagoneer (SJ) and 1984–1991 Jeep Grand Wagoneer (SJ).
The washer carries a limited five-year manufacturer warranty. Other dimensions and materials are not confirmed, so measure against your spindle before installing.
Key features
- Direct OE replacement built to original specifications
- Dana 44 spindle washer
- Limited five-year manufacturer warranty
- It fits the Wagoneer and Grand Wagoneer (SJ) models.
Spindle washer basics
A spindle washer sits between the spindle nut and the bearing assembly, helping set the preload and keep the hub position correct. Because the washer is under load every time the wheel turns, it can wear, flatten or pick up damage where the nut tightens against it. Inspect the washer for flat spots, cracks or grooves whenever the hub is opened.
When replacing the washer, clean the spindle thoroughly and confirm the washer sits flat before tightening the nut. Install it in the correct orientation and follow the adjustment steps for the hub, since preload affects bearing life. Replacing the washer alongside the bearing and seals can save another teardown later.
- Check the washer for flat spots or grooves
- Clean the spindle before installation
- Confirm the washer seats flat
- Replace bearing and seals at the same service
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16527.35 |
| UPC | 804314028701 |
| Component | Dana 44 spindle washer |
| Build | Direct OE replacement built to original specifications |
| Warranty | Limited five-year manufacturer |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1974–1983 Jeep Wagoneer and the 1984–1991 Jeep Grand Wagoneer, both SJ models.
Other Jeep models are not in the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One Dana 44 spindle washer.









