Overview
The Omix-ADA shifter bezel, part number 18886.94, is a black plastic bezel for AX4, AX5 and AX15 manual transmissions. A bezel is the trim ring around the shift lever opening, so the fit depends on the transmission.
It is built to original specifications and carries a limited five year warranty.
Key features
- Black plastic construction
- Made for AX4, AX5 and AX15 manual transmissions
- Built to original specifications.
- Covered by a limited five year warranty.
Fitting a shifter bezel
The bezel is the trim ring at the base of the shifter. It covers the gap between the console or floor opening and the shift lever. On an AX4, AX5 or AX15 manual, the bezel sits where the shifter boot meets the transmission tunnel, so it helps keep debris and moisture out of that gap. A bezel that fits well stays flat, holds its shape, and does not rattle when the lever moves through the gears.
Because the bezel is a plastic trim part, it is most often replaced after cracking from heat, sun exposure or a stressed mounting point. Check the mounting tabs and screw holes before installing. A new bezel should seat without forcing. If it does not, the old bezel or the boot underneath may be out of shape, and that is worth checking before tightening anything.
- Inspect the shifter boot underneath when the bezel is removed
- Clean the console or floor surface before setting the new bezel in place
- Tighten fasteners gradually so the plastic does not crack
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18886.94 |
| UPC | 804314236779 |
| Material | Black plastic |
| Transmissions | AX4, AX5, AX15 (manual) |
Vehicle fitment
The bezel is named for AX4, AX5 and AX15 manual transmissions and no vehicle years are given.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents against your installation before starting.









