Overview
The Omix-Ada 17430.19 is a standard-size piston ring set for Jeep engines, fitting CJ5, CJ7, SJ Cherokee, Wagoneer, Grand Wagoneer, Scrambler and YJ Wrangler models from 1972 to 1990. Omix-Ada builds the set to original Jeep specifications as a direct replacement.
Piston rings seal combustion pressure, control oil on the cylinder wall and carry heat from the piston to the cylinder. This ring set suits owners and shops rebuilding an engine in standard size.
Key features
- Standard size piston ring set
- Built to original Jeep specifications.
- Direct replacement design
- Part number 17430.19 and UPC 804314029609
Ring fit and engine wear
Piston rings work as a set, so the top, second and oil rings must each suit the piston and bore. End gap and side clearance are checked before installation, since too little gap can cause ring breakage when the engine heats up and too much can reduce compression. A machine shop can measure these values and fit the rings properly.
Ring life depends on cylinder condition and oil quality. Glazed or scored cylinder walls shorten ring life, so inspect the bore during a rebuild. Regular oil changes and a clean air filter also help the rings seal over time.
- Blue exhaust smoke can point to worn rings
- Rising oil consumption is a common sign of ring wear
- Lower compression often shows up as rough idle and lost power
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 17430.19 |
| UPC | 804314029609 |
| Size | Standard |
| Type | Piston ring set |
| Warranty | Limited five-year warranty from Omix-Ada |
Vehicle fitment
It fits these Jeep models: CJ5 (1972-1983), CJ6 (1972-1975), CJ7 (1976-1986), Cherokee SJ (1974-1983), Wagoneer SJ (1971-1983), Grand Wagoneer SJ (1984-1986), Scrambler (1981-1985), Commando (1972-1973), DJ5 (1972-1974), Wrangler YJ (1987-1990) and J-series trucks from 1968 to 1987.
Fitment applies to the years and models above. Check your vehicle’s year, model and trim against these years before ordering.
Installation notes
Measure ring end gaps and side clearances against the engine specification before the pistons go back in. Ring fitting is usually done by a machine shop during a rebuild, and that work should go to a qualified mechanic.
What’s included
One piston ring set, standard size.
Not included: pistons, bearings and gaskets for the engine rebuild.









