Overview
The Omix-Ada 18026.06 is a king pin bearing cup, a steering component for the front axle of older Jeep vehicles. Omix-Ada builds it as a direct OE replacement to original specifications.
It fits Jeep CJ3, CJ5 and CJ6 models, DJ and Dispatcher models, Jeepster and Tornado, Wagoneer SJ, Gladiator, J-series trucks, and Willys CJ-2, CJ-3, CJ-5, CJ-6, DJ-3, Panel and MB vehicles. The years run from 1941 to 1971.
Key features
- Direct OE replacement, built to original specifications per Omix-Ada
- King pin bearing cup for the front steering axle
- It fits many Jeep and Willys models.
- It has a limited five year warranty from Omix-Ada.
Front axle king pin service
The king pin bearing cup sits in the steering knuckle and carries the rotating load of the front wheel. Over time it wears, which allows play at the top and bottom of the knuckle and can make steering feel loose or vague. Check the bearing cup’s fit and the knuckle bore for wear before installing a new cup, since a worn bore can prevent the new part from seating correctly.
King pin work often involves the bushings, thrust bearings and seals around the knuckle, and wear in these parts tends to appear together. Clean all mating surfaces, use the correct press or driver to seat the cup evenly, and check the front alignment afterward. A careful, square installation helps the steering settle and reduces uneven tire wear.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18026.06 |
| Type | King pin bearing cup |
| Fitment type | Direct fit |
| Warranty | Five year limited warranty, provided by Omix-Ada |
Vehicle fitment
It fits the Jeep and Willys models named above, including Jeep CJ5 models from 1959–1960 and 1966–1971 (Base).
Models outside the listed Jeep CJ, DJ, FC, J-series and Willys lineup are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The item described is the king pin bearing cup itself.
Not included: Check other king pin components against your installation before starting.
