Overview
The Omix-ADA 18880.02 is a T90 shifter assembly, part number 18880.02, sold as a direct OE replacement. It fits early Jeep CJ3, CJ5 and CJ6 models from 1959 to 1960 and 1966 to 1971, and Willys CJ-2, CJ-3, CJ-5 and CJ-6 models from 1946 to 1958.
The shifter assembly is the lever and housing the driver uses to select gears. It is built for the T90 transmission, so match your transmission to the T90 before ordering.
Key features
- T90 shifter assembly, per the short description
- Direct OE replacement with original-specification build
- Fitment list runs from 1946 to 1971 across Willys and Jeep CJ models
- Omix-ADA part number 18880.02
Shifter wear and replacement
A shifter assembly takes the force from the driver’s hand and passes it through the linkage to the transmission. Over time the pivot points, bushings and detent parts can loosen, which shows up as vague gear selection or a lever that feels loose in the hand. Before replacing the assembly, inspect the shift linkage and the cable or rod connections, since worn linkage can feel like a bad shifter.
When fitting a new assembly to an older CJ, clean the mounting surface and check that the shift lever moves freely through each gear. Pay attention to any stiffness, binding or play once the assembly is bolted in place, and correct it before driving. Keeping the linkage lubricated and free of dirt helps the new part work as intended for longer.
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18880.02 |
| UPC | 804314019549 |
| Component | Shifter assembly |
| Transmission application | T90 |
| Fit type | Direct fit |
Vehicle fitment
Fitment list: 1959 Jeep CJ3 (Base); 1959–1960 and 1966–1971 Jeep CJ5 (Base); 1959–1960 and 1966–1971 Jeep CJ6 (Base); 1946–1949 Jeep Willys CJ-2; 1949–1958 Jeep Willys CJ-3; 1955–1958 Jeep Willys CJ-5; 1956–1958 Jeep Willys CJ-6.
CJ5 years after 1971, all CJ7 models and Wrangler models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents for mounting hardware or a gasket against your installation before starting.









