Overview
The Omix-ADA Front Hub, part 16705.01, is a direct OE replacement front hub for Willys and early Jeep models. It fits from the 1941-1942 Willys MB through the 1963 Jeep Wagoneer (SJ) and Gladiator, including CJ, DJ, FC, Jeepster, Panel and Sedan Delivery models in between.
It is built to original specifications and includes left-hand thread studs. Because the range is wide, match the model and year exactly before fitting.
Key features
- Direct OE replacement built to original specifications
- Left-hand thread studs included
- Front position
- Covers a wide range of Willys and early Jeep models
Hub service on older Jeeps
Front hubs on Willys and early Jeep models carry the wheel bearings and take the load of the front axle, so their condition has a direct effect on steering and brake feel. Worn hubs can show play when the wheel is rocked, a grinding noise at speed, or uneven tire wear. Because this range of vehicles is wide, the hub should be matched to the model and year before any work begins.
When a hub is removed, clean the spindle and inspect the bearing races for pitting or heat discoloration. Pack the bearings with a grease suited to wheel bearings and check the seal for damage before reassembly. Confirm the stud thread direction during the job, since mixing thread directions causes stripped threads. Tighten the hub nut to the factory procedure for your model.
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16705.01 |
| Manufacturer number | OAI16705.01 |
| UPC | 804314011420 |
| Position | Front |
| Studs | Left-hand thread |
| Warranty | Covered by a limited five-year warranty from Omix-ADA. |
| Fitment type | Direct fit |
Vehicle fitment
It fits the Willys MB, the Willys 1-Ton, CJ-2, CJ-3, CJ-5 and CJ-6, the Jeepster, the Panel and Sedan Delivery, the 1959-1960 CJ3, CJ5, CJ6 and DJ3, the 1957-1958 F4, the 1958-1963 FC150, the 1963 FC170 and FC170HD, the 1963 Gladiator, J-100 and Wagoneer (SJ), the 1962 Tornado, the 1961-1962 Utility and the 1961-1963 Dispatcher.
Jeep models from 1964 onward and Wrangler models do not fit this hub. Confirm fit for your vehicle’s year, model and trim before choosing this hub.
What’s included
One front hub with left-hand thread studs.









