Overview
The Crown Automotive front hub assembly, part 52060398AC, fits the driver or passenger side front position of the Jeep Wrangler JK. It is available for two-door and four-door bodies in the 2007–2010 model years.
Crown Automotive positions the part as a direct fit replacement for the front hub, so the hub assembly is the item to replace when the front hub on the JK needs to be renewed.
Key features
- Front hub assembly
- Works on the driver or passenger side
- Available for two-door and four-door models
- Direct fit replacement
Signs the hub needs replacing
A front hub often wears out through its bearing rather than the hub body itself. Typical symptoms are a humming or growling noise that rises with vehicle speed and changes when turning, a wheel with play or a wobble, and uneven tire wear on that side. Diagnose it with the vehicle safely supported by rocking the wheel at the top and bottom to feel for movement.
On a Wrangler JK, the front hub works with the axle, the brake rotor, the caliper and the steering knuckle, so the surrounding parts should be inspected while the hub is off. Check the rotor face, the brake hardware, the axle seal, and any wiring that runs near the hub. Clean the mounting surfaces before fitting so the new assembly seats square.
- Inspect the axle seal and axle splines for wear
- Torque fasteners to the values given in the service manual
- Recheck wheel bolts after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 52060398AC |
| Manufacturer number | CRO52060398AC |
| UPC | 848399038767 |
| Position | Front, driver or passenger side |
| Body style | Two-door and four-door |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2010 Jeep Wrangler (JK), in both two-door and four-door bodies.
It does not fit 2011 and later JK models or the Wrangler JL. Confirm fit against your year, model and trim before choosing this part.
What’s included
One front hub assembly.









