Overview
The Omix-Ada fender liner rivet, part number OAI11620.60, is a replacement rivet for the fender liners on Jeep Cherokee (XJ) and Wrangler (TJ) models from 1997 to 2001. It replaces OE number 34202672 and is sold individually.
Omix-Ada parts are built to meet or exceed OE standards. A single rivet suits the case where one fastener has been lost or broken and the rest of the fender liner hardware is still sound.
Key features
- Replacement for the OE fender liner rivet, OE number 34202672
- Direct-fit listing for the 1997–2001 Cherokee XJ and Wrangler TJ
- Made by Omix-Ada, which states its parts meet or exceed OE standards
- Sold individually rather than as a kit
Fender liner fastener care
Fender liner rivets are typically push-in fasteners that hold the liner to the body edge. Heat, road grime and years of flexing cause the plastic to lose its grip, and a rivet that spins freely or pulls out is worn even if the head looks fine.
Replacing one rivet is simple, but the hole matters. Remove the old fastener without tearing the liner, clean out grit and debris, and seat the new rivet until it is flush. Avoid forcing a rivet that does not seat, since an oversized push can crack the surrounding plastic.
- Check the liner edge for sagging or tears
- Clean the mounting hole before reinstalling
- Replace neighbors that show cracks or missing heads
- Recheck liner alignment after the first drive
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI11620.60 |
| Replaces OE number | 34202672 |
| Part type | Fender liner rivet |
| Quantity | Sold individually |
| Fitment type | Direct Fit |
Vehicle fitment
The manufacturer fitment list covers the 1997–2001 Jeep Cherokee (XJ) in Classic, Country, Limited, SE, and Sport trims, and the 1997–2001 Jeep Wrangler (TJ) in SE, Sahara, and Sport trims.
Model years outside 1997–2001 are not in the list, so Cherokee XJ and Wrangler TJ years from before 1997 or after 2001 are not confirmed. Confirm your vehicle’s year, model and trim before ordering.
What’s included
This is a single fender liner rivet, sold individually. Inspect the rest of the fender liner hardware for wear before installing.










