Overview
The Omix-Ada 11609.27 is a nylon blind rivet for factory fender flares, sold as a direct OE replacement fastener for Jeep. It is for the 2007-2018 Jeep Wrangler (JK).
It is built to original specifications, so it matches the fastener the factory used. A limited five-year warranty comes with it.
Key features
- Nylon construction
- Built to original specifications as a direct OE replacement
- Designed for factory fender flares
- Fits the 2007-2018 Jeep Wrangler (JK)
- Limited five-year warranty
Fastener replacement tips
Blind rivets hold fender flares by expanding behind the panel, so the fastener is only as good as the hole it sits in. Check the mounting holes for elongation or cracks before installing a new rivet, since a worn hole will not hold the flare firmly. A rivet that spins in the hole usually means the hole needs attention or the flare is loose.
Nylon fasteners are light and resist corrosion, which suits areas exposed to water and road spray. They do not handle heavy impact as well as metal, so check the flare after trail runs where branches or rocks may hit it. When removing an old rivet, drill out the center carefully to avoid enlarging the hole.
- Check mounting holes for wear before installing
- Replace a rivet that spins instead of holding
- Inspect flares after rough trail use
- Keep spare rivets with your trail kit
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 11609.27 |
| UPC | 804314251567 |
| Material | Nylon |
| Type | Blind rivet |
| Application | Factory fender flares |
| Warranty | Limited five-year warranty |
| Fit type | Direct fit |
Vehicle fitment
It is a direct fit for factory fender flares on the 2007-2018 Jeep Wrangler (JK). The TJ and JL Wrangler generations fall outside that range.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One nylon blind rivet. Check the package contents against your installation before starting.
