Overview
The Crown Automotive Fender Flare Hardware Kit, part number 5AHRRKIT, is replacement mounting hardware for rear fender flares on the 1987–1995 Jeep Wrangler YJ.
The kit includes 14 screws and 14 nuts. Compare the fasteners with the rear flare you are mounting before installation.
Choosing and fitting rear flare hardware
Rear flares take more movement than front ones because the rear wheels absorb bumps and tire scrub at the back of the wheel opening. A loose rear flare can flap against the tire or rattle in the wheel well, so it needs a firm, even fit. Lay the old screws and nuts beside the new set and confirm the thread pitch matches before you start.
Start by removing the old flare carefully to avoid bending the panel edge. Clean the mounting holes and check for rust around them, because rust can keep fasteners from seating. Tighten in a cross pattern, then re-check after the first drives and after any trail work that flexes the body.
- Inspect the flare for cracks at the mounting points
- Replace nuts that no longer grip the thread
- Keep a note of which hole takes which screw
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 5AHRRKIT |
| UPC | 848399046816 |
| Front or rear | Rear |
| Contents | 14 screws and 14 nuts |
| Fitment type | Direct fit |
Vehicle fitment
It fits the rear fenders of the 1987 to 1995 Jeep Wrangler YJ.
The fit list does not include the Cherokee XJ or the TJ, LJ or JK Wrangler. Confirm your vehicle’s year, model and trim before ordering.
What’s included
14 screws and 14 nuts for the rear fenders.









