Overview
The Omix-Ada OAI16537.02 is a rear axle hub for AMC Model 20 axles, with studs included. It fits the 1976–1983 Jeep CJ5, the 1976–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler.
The hub is a direct OE replacement built to original specifications. It is a rear-position part and carries a limited five-year warranty from Omix-Ada.
Key features
- Replacement rear axle hub for the AMC Model 20
- Studs included with the hub
- Built to original specifications
- Direct-fit listing for three CJ and Scrambler model ranges
- Limited five-year warranty from Omix-Ada
Hub wear and bearing checks
The rear hub carries the wheel bearing load and locates the wheel on the axle, so wear there shows up as noise, vibration or wheel play. A hub that has been pounded in or pulled too far can loosen the studs, so inspect each stud for thread damage and cracks before reuse. Rust and seal failure around the hub are other common signs that the bearing needs attention.
When a hub is replaced, the wheel bearings and seals are usually serviced at the same time, because a fresh hub will not last long with a worn bearing. Clean the mounting face so the hub sits flat against the axle flange, and tighten the lug nuts evenly in a star pattern after installation.
Brake drum or rotor condition also matters, since a warped or scored surface can cause vibration that looks like a hub problem. Check for play and noise after the first trip, and recheck lug nut tightness after a short drive.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI16537.02 |
| Position | Rear |
| Axle | AMC Model 20 |
| Included | Studs |
| Warranty | Limited five-year warranty |
Vehicle fitment
It fits these models across their trim levels: 1976–1983 Jeep CJ5, 1976–1986 Jeep CJ7 and 1981–1985 Jeep Scrambler.
The Wrangler (YJ) and Cherokee (XJ) are not on this list, and CJ models outside 1976–1986 are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
The hub comes with studs.









