Overview
The Dana Spicer Axle Hub Assembly, part 10021363, is a front wheel hub for the Dana 44 front axle. It fits the 2007–2018 Jeep Wrangler JK in both two-door and four-door body styles.
The hub is an OE component built to original equipment requirements, so it matches the JK’s front axle as supplied from the factory.
Key features
- Front wheel hub assembly
- Built for Dana 44 front axles
- Designed to the original equipment requirements
- It fits two-door and four-door JK models.
Hub and bearing service
A front wheel hub carries the wheel bearing and mounts the brake rotor and wheel studs, so it takes steering and braking loads on every drive. Play at the wheel, a grinding or humming noise that changes with speed, or heat at the hub after a drive can all point to a worn bearing or hub. Inspect the hub face and studs for damage before fitting a new assembly.
When replacing the hub, clean the mounting face and check the seal surface on the axle. Torque the mounting bolts to the value in the service manual and recheck after the first few drives. If the vehicle has been driven on rough trails, inspect the hub for seal leakage after those drives as well.
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 10021363 |
| Manufacturer number | D/S10021363 |
| Position | Front |
| Axle | Dana 44 front |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK), covering two-door and four-door bodies in that range.
The JL generation and the Dana 30 front axle are not covered by this fitment entry. Confirm your vehicle’s year, model and trim before choosing this part.
Installation notes
The front axle must be a Dana 44 before fitting, since this hub is built for that axle.
What’s included
One front wheel hub assembly.









