Overview
The Omix-ADA bellcrank pivot stud, part 16919.12, is a replacement pivot stud for the clutch bellcrank on 1972–1975 Jeep CJ5 and CJ6 models. Two are needed for each installation.
The pivot stud is the pin the bellcrank turns on. Omix-ADA builds it to the original specifications as a direct OE replacement, so it is meant to slot into the factory bellcrank position on the listed CJ models.
Key features
- Quantity of two required
- Direct OE replacement built to original Jeep specifications
- Covers the 1972–1975 Jeep CJ5 and CJ6.
- Omix-ADA part number 16919.12
Clutch linkage pivot wear
The pivot stud is the pin the bellcrank rotates on, so its condition sets how smoothly the clutch linkage moves. As a stud wears, the bellcrank can develop play that makes the pedal feel loose or inconsistent. Because the stud carries load each time the clutch is used, a worn stud can also damage the bellcrank bore if left in service.
When the linkage is apart, clean each stud and check the shank for grooves, flat spots or bending. Inspect the bellcrank bushings and the clips that hold them, since a worn bushing can cause the same looseness as a worn stud. Replacing studs in pairs keeps both sides of the linkage matched, and a light coat of grease on the stud helps reduce future wear.
- Measure play at the bellcrank by hand before removing
- Check the shank for grooves or bending
- Inspect the bellcrank bore for elongation
- Replace bushings alongside the studs
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16919.12 |
| UPC | 804314019259 |
| Product type | Clutch bellcrank pivot stud |
| Quantity required | 2 |
Vehicle fitment
It fits the 1972–1975 Jeep CJ5 and the 1972–1975 Jeep CJ6.
Other Jeep models, including the Wrangler, are not on the list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Compare the stud count and hardware against your installation before starting.









