Overview
The Omix-Ada axle snubber, part number 18270.11, is a front rubber bump stop for Jeep and Willys models from 1941 to 1971. It limits upward axle travel. It is a factory replacement design with a metal mounting plate and molded rubber, and the bump stop extends down 1-3/8 inch from the frame.
Key features
- Factory replacement design for Jeep and Willys axles
- Metal mounting plate with molded rubber bump
- Black finish
- Extends 1-3/8 inch down from the frame
- Front position
Axle travel and bump stops
A front bump stop limits how far the axle can travel upward, which protects the springs, brake lines and frame from metal-to-metal contact. On older solid-axle Jeeps, the stop works alongside the leaf springs and shock absorbers, so its position affects how the axle sits at full compression. When the stop is worn or missing, the axle can travel far enough to strike the frame, and that impact can be felt through the steering and body.
Rubber stops tend to crack, flatten or take a set over time, especially in areas with road salt or heavy off-road use. Replacing the stop is a simple way to restore its original travel limit, but check it against the frame mounting pattern first, since shock or spring changes can shift the axle position. Check the brake lines and shock mounts for rubbing after any replacement.
- Look for cracks, flattening or missing rubber
- Check brake lines for rubbing at full compression
- Replace shock mounts and bushings if they are worn
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18270.11 |
| UPC | 804314019501 |
| Position | Front |
| Type | Rubber bump |
| Finish | Black |
| Mounting plate | Metal, with molded rubber attached |
| Extension from frame | 1-3/8 inch |
| Mounting pattern | 4 hole from center to center |
Vehicle fitment
Omix-Ada lists fitment for 1941–1971 Jeep and Willys models, including the 1959–1960 and 1966 Jeep CJ3, the 1959–1960 and 1966–1971 Jeep CJ5 and CJ6, the 1961–1967 Dispatcher, the Jeep DJ3, DJ5 and DJ6, the 1957–1958 F4, the 1962 Tornado, and the Willys CJ-2, CJ-3, CJ-5, CJ-6, DJ-3, Panel, Sedan Delivery and MB models.
CJ7 and later Jeep models do not match this part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the 4 hole center-to-center pattern against your frame before fitting, and confirm the 1-3/8 inch extension clears the axle at full compression. Plan on the mounting hardware your setup uses.
What’s included
The metal mounting plate with molded rubber is the bump stop itself. Plan on the mounting bolts your setup uses.








