Overview
The N-Fab 2 Inch Nerf Steps in gloss black, part number T1678CC, are wheel-to-wheel nerf bars for the 2016–2023 Toyota Tacoma in the Limited, SR, SR5, TRD Off-Road, TRD Pro, TRD Sport and Trail trims. N-Fab makes nerf bars, pre-runner parts and other off-road accessories, and this 2 inch step is one of its tubular bars for trucks and SUVs.
The tube is heavier gauge .084 wall steel in an all-welded, one-piece construction rather than thinner tube. Each part is zinc coated for corrosion protection and then finished with a thick layer of high-gloss powder coat.
Owners who want a gloss black step bar for a 2016–2023 Tacoma with a welded, zinc-coated tube can compare the specifications below. The stated length is wheel to wheel, so check it against the body and wheel layout of your truck before fitting.
Key features
- 2 inch tubular nerf bar profile
- Heavier gauge .084 wall steel tube
- All-welded, one-piece construction
- Zinc coated before finishing
- Thick high-gloss powder coat in gloss black
- Wheel-to-wheel length
Choosing the right setup
A wheel-to-wheel nerf bar runs the full length of the cab area between the wheels, so it protects more of the lower body than a short step. That coverage is useful on trails with brush and rock, but it also means the bar sits lower and closer to the ground. Measure your Tacoma’s clearance and the angle you need when leaving a ledge before deciding how far the bar should extend.
Steel bars with a zinc coat and powder-coat finish hold up well to scrapes, yet any chip exposes the metal below. Keep a small amount of touch-up coating for the chips you are most likely to get. Mounting brackets often get replaced along with the bars, so check the bracket condition on your truck first.
- Check clearance at the lowest point of the bar
- Inspect the zinc layer and powder coat after trail use
- Replace worn mounting hardware when fitting new bars
Specifications
| Brand | N-Fab |
|---|---|
| Part number | T1678CC |
| Tube | 2 inch, .084 wall steel |
| Construction | All-welded, one-piece |
| Corrosion protection | Zinc coat |
| Finish | Gloss black, high-gloss powder coat |
| Length | Wheel to wheel |
| Fitment | Direct fit |
Vehicle fitment
N-Fab lists these steps for the 2016–2023 Toyota Tacoma in the Limited, SR, SR5, TRD Off-Road, TRD Pro, TRD Sport and Trail trims.
Tacoma model years before 2016 are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the package contents before starting the job, and confirm any drilling requirement for your truck.
What’s included
Check the package contents before starting the installation.










