Overview
The MTS Company 0042-RH is a high density polyethylene replacement fuel tank for under-seat mounting on 1965–1972 Jeep CJ5 and CJ6 models, plus the 1966–1968 CJ5A and CJ6A.
The tank is built from high density polyethylene with no welds or seams. Its walls are nearly a quarter inch thick, and the polyethylene insulates against condensation. It carries a guarantee against rusting through for the life of the vehicle, is made in the U.S.A., and installs with the original mounting hardware.
Key features
- High density polyethylene body with no welds or seams
- Walls nearly a quarter inch thick
- Its polyethylene insulation reduces condensation.
- Guaranteed by MTS not to rust through for the life of the vehicle
- Installs with the original mounting hardware
- Made in the U.S.A.
Fuel tank care after the swap
Under-seat tanks sit inside the cab area, so a leak or fumes are easy to notice but also harder to ignore. After the swap, run the engine and look over every fitting, filler neck and hose clamp for seepage. Check again after the first few drives and then at each oil change.
Old tanks often leave behind grit, rust flakes and old sealant around the mounting points. Clean those areas thoroughly before setting the new tank in place, since debris trapped under a tank can rub through hoses over time. Fuel pickup lines and clamps that look hardened are worth replacing during the same job. Let the area dry fully before reinstalling trim or carpet.
- Replace cracked or stiff fuel hoses
- Inspect the filler neck seal
- Keep the cab floor dry and free of fuel odor
Specifications
| Brand | MTS Company |
|---|---|
| Part number | 0042-RH |
| UPC | 70000640503 |
| Material | High density polyethylene |
| Wall thickness | Nearly a quarter inch |
| Mounting position | Under the seat |
| Fitment type | Direct fit |
| Capacity | Standard |
Vehicle fitment
It fits the following vehicles:
- 1965–1972 Jeep CJ5 (Base)
- 1966–1968 Jeep CJ5A (Base)
- 1965–1972 Jeep CJ6 (Base)
- 1966–1968 Jeep CJ6A (Base)
The fitment covers CJ5 and CJ6 models only. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The tank uses the original mounting hardware, so fitting it is a swap for the existing tank with no drilling or welding described. Drain the old tank first and keep sparks and open flames away from the work area.
What’s included
The tank is the item covered here. Check the package contents against your installation before starting.












