Select your vehicle

Mr. Gasket Company Carburetor Adapter Kit 9/16 in. – 1937

Mr. Gasket Company

Shop on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Slickrock 4X4 is a participant in the Amazon Associates Program. As an Amazon Associate we earn from qualifying purchases.

  • Mr. Gasket Company carburetor adapter kit, 9/16 in., part number MRG1937
  • Adapts from a 2 bbl carburetor to a 2 bbl intake
  • Gaskets, studs, nuts and washers included
  • Universal fit for 2 bbl carburetor and intake setups

Description

Overview

The Mr. Gasket Company carburetor adapter kit, 9/16 in., part number MRG1937, adapts from a 2 bbl carburetor to a 2 bbl intake.

The kit comes with gaskets, studs, nuts and washers. Its adapter is die cast aluminum.

Mounting and leak checks

A carburetor adapter sits between the carburetor and the intake, so its job is to carry the load and seal the joint. Clean both mating surfaces before assembly, removing old gasket material and any oil film. Set the gaskets in place first, then start every stud by hand so the adapter sits square before the nuts are tightened.

Torque the fasteners gradually in a crisscross order, since uneven pressure can warp the aluminum. Once the engine has warmed, check for fuel smell, seepage and hissing around the joint. A small leak at an adapter is usually a seating issue rather than a faulty part, so recheck the bolts first before replacing anything.

  • Use a straight edge on the mating surface
  • Replace any gasket that is torn or hardened
  • Check the joint again after the first drive

Specifications

Brand Mr. Gasket Company
Part number MRG1937
Size 9/16 in.
Adapts from 2 bbl
Adapts to 2 bbl intake
Material Die cast aluminum
Included hardware Gaskets, studs, nuts, washers
Fitment Universal Fit

Vehicle fitment

It is a universal fit, so it is not tied to one particular vehicle. Match the 9/16 in. size and the 2 bbl bore layout to your carburetor and intake before installing.

Confirm your vehicle’s year, model and trim before ordering.

Installation notes

Tighten the nuts in a crisscross pattern once the gaskets are seated, and check the joint for leaks after the engine has run.

What’s included

Gaskets, studs, nuts and washers are included. Count the pieces on arrival and compare them with your intake’s mounting holes.

Questions & Answers

What does Mr. Gasket MRG1937 adapt?

MRG1937 is a 9/16 in. carburetor adapter kit that adapts from a 2 bbl carburetor to a 2 bbl intake. It is a universal fit, so it is not tied to one vehicle, and the die cast aluminum adapter mounts between the two.

Is the MRG1937 kit universal fit?

Yes. It is a universal fit kit, so no particular vehicle applies. Confirm the 2 bbl bore layout and the 9/16 in. size against your own carburetor and intake before installing.

Which hardware is supplied with the adapter?

Gaskets, studs, nuts and washers come with the kit. Inspect each piece and compare the studs with your intake's mounting holes before installing. Check the count against your installation before starting.

Can the adapter fix a carburetor that is not sealing?

The adapter fixes the mounting layout, not a worn carburetor. Replace the gaskets during installation and recheck the joint after the engine warms up. If leaks remain, inspect the mating surfaces for warping.

Find it on Amazon

Compare current versions and compatible options on Amazon, then check out with your Amazon account.

Shop on Amazon