Overview
Method Race Wheels offers this 701 Trail Series 17×8.5 wheel in Bronze, part number MRWMR70178580900, as a one-piece cast aluminum off-road wheel. It has an 8 on 6.5 bolt pattern, a 131 center bore, an offset of 0 and a backspacing of 4.75. Because Method labels the wheel universal fit, the bolt pattern and center bore are the first things to verify.
Bead Grip is patent pending and is designed to keep the tire seated and gripping at lower air pressures. The wheel adds a reinforced inner lip from race wheel design and a safety hump on each bead seat to stabilize the tire. The wheel was developed with finite element analysis and field testing, and it is built for off-road racing use.
Key features
- Bronze windowed wheel in the Trail Series.
- Cast aluminum 356, one piece, T6 heat treated.
- Bead Grip design with patent pending status.
- Reinforced inner lip from race wheel design.
- Safety hump on the inner and outer bead seat.
- Method reports finite element analysis and field tests were part of development.
Mounting and bead seating
A bronze finish is a cosmetic choice, but bead seating is what keeps a trail tire working. When the bead sits evenly against the seat, the tire holds air at low pressure and resists rolling off the rim over rocks. Clean the seat of dirt and old rubber before mounting, since grit under the bead is a common cause of slow leaks.
Lower pressures take more care in setup. Air down in small steps, then check that the bead stays even around the rim. Once you air back up for the road, inflate slowly and check each side for a steady seal. Wheels with a wide tire footprint may need more attention to clearance than narrow wheels.
Plan the hardware before the wheel arrives. Pick lug nuts and valve stems that match your hub and wheel, and keep center caps aside until fitment is confirmed. Recheck torque after the first short drive, since new wheels often settle a little as the mounting surface seats.
Specifications
| Brand | Method Race Wheels |
|---|---|
| Part number | MRWMR70178580900 |
| Series | 701 Trail Series (MR701 Bead Grip) |
| Wheel diameter | 17 Inches |
| Wheel width | 8.5 Inches |
| Bolt pattern | 8 on 6.5 |
| Center bore | 131 |
| Offset | 0 |
| Backspacing | 4.75 |
| Construction | One-piece cast 356 aluminum, T6 heat treatment |
| Style | Windowed |
| Finish | Bronze |
Vehicle fitment
No vehicle, year or chassis is named for this wheel. The universal fit label is only a starting point, since the 8 on 6.5 bolt pattern and 131 center bore decide whether a hub matches.
Compare bolt pattern and center bore with your vehicle’s hub specifications. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Check the 8 on 6.5 bolt pattern and the 131 center bore against the hub before any mounting. Offset 0 and backspacing 4.75 set how far the wheel sits in the well, so confirm clearance with the tire you plan to run.
What’s included
One wheel in Bronze from the Method 701 Trail Series.
Not included: Tires, lug nuts, valve stems and center caps need to be added separately.
















