Overview
The K&N 63-1573 Performance Air Intake Kit with Snorkel is an enclosed cold-air intake for the 2012–2018 Jeep Wrangler JK, 2 and 4 door models with the 3.6L engine. It replaces the factory air filter and air intake housing, and it adds a snorkel that pulls air from outside the engine compartment for off-road driving.
K&N’s design reduces air intake restriction so the engine can inhale more air than the factory assembly. The company ties that extra air to more usable power and acceleration throughout the RPM range and to a guaranteed power gain. Fresh air travels through the low-restriction snorkel tubing before reaching the filter and then the throttle body. The air box is a roto-molded replacement that holds a chrome-topped, cone-shaped high-flow filter rated for up to 100,000 miles before servicing, depending on driving conditions.
Key features
- Snorkel system designed for the Jeep Wrangler to bring in fresh air from an ideal location in extreme off-road conditions.
- Enclosed air box keeps the filter separated from hot engine compartment air.
- Removable air box lid allows easy access to service the washable, reusable filter.
- Rotational molded air box, inlet tube and snorkel designed together for fit and ease of installation.
- Aerodynamically engineered intake tube smooths and straightens airflow into the throttle body.
- Heat shield included to protect the snorkel system.
- Built to improve throttle response and engine sound.
Snorkel setup and trail use
A snorkel raises the air inlet above the lower engine bay, so the engine draws air from higher and typically cleaner than the area near the ground. On trails, the snorkel helps keep dust and splash away from the filter, which matters most during long dusty runs.
Routing matters. Keep the snorkel tube clear of hard contact points and check the mounting after rough trails. A heat shield protects the tubing from nearby hot parts, so inspect it for cracks or loose fasteners as well. Tighten fasteners by hand first to avoid cracking the tube.
- Check the snorkel clamps after rough trails
- Keep the air box lid sealed
- Inspect the heat shield for heat damage
- Clean the washable filter after dusty trips
Specifications
| Brand | K&N Filter |
|---|---|
| Part number | 63-1573 |
| UPC | 24844363916 |
| Intake type | Cold air |
| Filter housing type | Full enclosure |
| Filter type | Oil |
| Inlet tube | Included |
| Fitment type | Direct fit |
| Engine | 3.6L |
| Snorkel system | Included |
| Heat shield | Included |
| Filter service interval | Up to 100,000 miles, depending on driving conditions |
| Warranty | K&N Million Mile Limited Warranty |
Vehicle fitment
Intended for 2012–2018 Jeep Wrangler (JK) vehicles, 2 and 4 door models with the 3.6L engine. Confirm your vehicle’s year, model and trim before ordering.
The 2007–2011 JK years and the JL generation are not covered by this application. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installation is fairly straightforward and typically takes 90 minutes or less. The intake reuses the vehicle’s existing factory mounting points.
What’s included
The kit includes the enclosed replacement air box with its washable, reusable filter, the snorkel system, the heat shield for the snorkel, and the inlet tube.


































