Overview
The K&N Filter 57-2583 is a 57 Series performance intake kit, part number 57-2583, for the 2011–2014 Ford F-150 with the 3.5L V6 EcoBoost engine. It replaces the restrictive factory air filter and air intake housing in those models, routing air into the engine’s turbo inlet through a smooth, straightened tube.
The tube smooths and straightens airflow to reduce intake restriction, so the engine can draw in more air than with the factory assembly. It is designed to improve throttle response and engine sound.
Key features
- Replaces the entire factory air intake system
- Aerodynamically engineered intake tube feeding the turbo inlet
- Oversized cone-shaped K&N high-flow air filter with a chrome top
- Heat shield that installs into the original air box space
- Tube accommodates the factory EVAP hose, plus the mass air sensor and pressure sensor where equipped
- Filter usable for up to 100,000 miles before service, depending on driving conditions
- Washable and reusable lifetime air filter
- Backed by the K&N Million Mile Limited Warranty
Working around the air box
Replacing an air box means working in a crowded engine bay, so plan the job before opening anything. Lay out the tools, note how the factory clips and hoses are routed, and take a photo of the sensor connectors so reassembly is accurate. Take care with the mass airflow sensor and any pressure sensor, since a bent pin or cracked connector causes airflow faults.
Once the new tube and heat shield are in place, check that the EVAP hose and sensor wires are not pinched or stretched. Recheck every clamp after a short drive, because heat cycles can loosen them. A cone-style filter should be checked for proper seating in its housing, since an unseated filter can let dirt past the element.
- Photograph sensor connectors before disconnecting
- Recheck clamps after the first drive
Specifications
| Brand | K&N Filter |
|---|---|
| Part number | 57-2583 |
| UPC | 24844361295 |
| Series | 57 Series |
| Engine application | 3.5L V6 EcoBoost |
| Vehicle application | 2011–2014 Ford F-150 |
| Intake type | Cold Air |
| Filter housing type | Full Enclosure |
| Filter type | Oil/Dry |
| Filter service interval | Up to 100,000 miles, depending on driving conditions |
| Inlet tube | Included |
| Heat shield | Included |
| Fitment | Direct Fit |
| Warranty | K&N Million Mile Limited Warranty |
| CARB E.O. # | D-269-48 |
Vehicle fitment
Fits the 2011–2014 Ford F-150 in the FX2, FX4, King Ranch, Lariat, Limited, Platinum, XL and XLT trims. The kit is built around the factory mounting points and air box space of those trucks.
Not for the 2015 and newer F-150 or the 2010 and earlier F-150. Make sure your year, model and trim appear in the fitment entries above before ordering.
Installation notes
Installation usually takes 90 minutes or less using the existing factory mounting points. A screwdriver, ratchet set and several wrenches are needed. Remove the factory air filter and housing before fitting the new tube and heat shield.
What’s included
The kit includes the intake tube, the chrome-topped K&N high-flow air filter and the heat shield that fits the original air box space.
Not included: Tools. A screwdriver, ratchet set and several wrenches are needed for installation.




















