Overview
The K&N 57-1553 is a 57 Series FIPK performance air intake kit for the 2007–2011 Jeep Wrangler (JK). It replaces the factory air filter and air intake housing, using a chrome-topped, high-flow, oversize cone-shaped filter and a heat shield that installs into the former air box space.
The kit is a cold-air intake with a partial-enclosure filter housing and a free-flowing high-density polyethylene intake tube that directs air to the throttle body. It is 50 State legal under CARB E.O. # D-269-37, and the filter is washable and reusable.
Key features
- Replaces the entire factory air intake system
- Free-flowing high-density polyethylene intake tube
- Cold-air intake design with a partial-enclosure filter housing
- Heat shield installs into the previous air box space
- Tube accommodates the factory air temperature sensor and crankcase vent hose
- Washable, reusable oil-type filter; it can go up to 100,000 miles between services, depending on driving conditions
- 50 State legal, CARB E.O. # D-269-37
- Installs at the existing factory mounting points; K&N says usually in 90 minutes or less
Cold-air intake considerations
A cold-air intake draws air from a cooler point than the stock box, and the intake tube plays a role in how air reaches the throttle body. Changes may be noticed in throttle response and intake sound, though results depend on the rest of the engine. Keep the sensor and crankcase vent connections sealed so the engine management system sees accurate readings.
Water and road spray are the main concerns with any open intake, so park with the intake location in mind and avoid deep puddles. Clean and re-oil the filter on the schedule suited to your driving, and inspect the tube for cracks or loose clamps after rough trails.
- Inspect clamps and tube joints after rough trails
- Keep the filter clean and properly oiled
- Avoid deep water crossings with the intake exposed
Specifications
| Brand | K&N Filter |
|---|---|
| Part number | 57-1553 |
| UPC | 24844232304 |
| Product type | Performance air intake kit (FIPK) |
| Series | 57 Series |
| Intake type | Cold air |
| Filter type | Oil, washable and reusable |
| Filter housing | Partial enclosure |
| Inlet tube | Included, high-density polyethylene |
| Service interval | Up to 100,000 miles, depending on driving conditions |
| Emissions status | 50 State legal, CARB E.O. # D-269-37 |
| Warranty | K&N Million Mile Limited Warranty |
| Tools mentioned | Screwdriver, ratchet set, Allen wrench |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2007–2011 Jeep Wrangler (JK), including 70th Anniversary, Rubicon, Sahara, Sport, X and the Unlimited versions of those trims. Use the year range to check fit.
Confirm fit for your vehicle’s year, model and trim before ordering, since the covered range ends with 2011.
Installation notes
Installation uses the existing factory mounting points, with a screwdriver, a ratchet set and an Allen wrench. Disconnect the battery before starting, keep the intake clear of heat sources and moving parts, and make sure hose clamps and the air temperature sensor and crankcase vent connections are secure. Check for air leaks after installation, and re-check the fasteners after the first miles of driving. Follow the instructions for filter cleaning and re-oiling.
What’s included
An air intake system with a chrome-topped K&N high-flow air filter, a heat shield for the air box space and an intake tube.












