Overview
The K&N Filter 57 Series Performance Air Intake Kit, part number 57-3066, is a cold air intake for 2007–2010 heavy-duty pickups: Chevrolet Silverado 2500 HD and 3500 HD, and GMC Sierra 2500 HD and 3500 HD. It replaces the factory filter, air box and air path, and K&N estimates a gain of 20 HP from the intake.
The intake uses a free-flowing tube, a washable oil-type filter and a partial enclosure housing. The filter is washable and reusable, and the intake is covered by the K&N Million Mile Warranty. It is 50 State Legal under CARB E.O. number D-269-36 and is made for 2007–2010 heavy-duty pickups.
Key features
- Estimated gain of 20 HP
- Free-flowing high density polyethylene intake tube
- Washable and reusable lifetime air filter
- Partial enclosure housing with a cold air intake design
- Direct Fit design for the listed heavy-duty models
- Backed by the K&N Million Mile Warranty
Heavy-duty truck intake notes
Heavy-duty trucks spend much of their working life under load, pulling trailers, carrying loads and climbing grades. Intake airflow matters most in those conditions, when the engine needs a steady supply of air. A replacement intake changes how air reaches the throttle body, so the filter and tube should be inspected after setup to confirm the seal is holding.
Driving on dusty job sites or gravel roads puts more dirt into the intake than highway use. A washable filter helps control that cost, but it has to be cleaned and re-oiled on a regular schedule. Keep a spare filter if the truck is used in harsh conditions, so a clean element is ready when the first one needs service.
- Check the clamps after the first tow or hauling job
- Inspect the tube for cracks after heavy use
- Keep the filter seal clean when cleaning
- Reinstall the housing lid securely after each service
Specifications
| Brand | K&N Filter |
|---|---|
| Part number | 57-3066 |
| UPC | 24844283979 |
| Estimated power gain | 20 HP |
| Intake type | Cold Air |
| Filter housing type | Partial Enclosure |
| Filter type | Oil |
| Inlet tube | Included |
| Fitment | Direct Fit |
| CARB E.O. number | D-269-36 |
| Warranty | K&N Million Mile Warranty |
| Made in | The U.S.A. |
Vehicle fitment
The 57-3066 fits these 2007–2010 models: Chevrolet Silverado 2500 HD (LT, LTZ, WT) and Silverado 3500 HD (LT, LTZ, WT); GMC Sierra 2500 HD (SLE, SLT, WT) and Sierra 3500 HD (SLE, SLT, WT).
Light-duty 1500 series trucks, Suburban and Tahoe models, and model years after 2010 are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
K&N gives an installation time of usually 90 minutes or less. The partial enclosure housing takes the place of the factory air box, so the stock intake assembly comes out first. Check that clamps and hose joints seal fully after the tube is set, since a loose joint can let unfiltered air bypass the filter.
What’s included
The inlet tube is included, along with the washable K&N air filter and the housing components for the kit.









