Overview
The Jeep speedometer pinion O-ring, part number 6035709, is an O-ring seal for the speedometer pinion at NP231 transfer cases. Replacing it is meant to prevent leaks from the speedometer cable connection.
It is a direct fit for NP231 transfer cases, rather than a vehicle-specific part.
Key features
- Seals the cap that retains the speedometer gear
- Designed for NP231 transfer cases
- Helps prevent leaks at the speedometer cable
- Direct fit
Speedometer seal maintenance
The speedometer pinion sits where the speedometer cable connects to the transfer case, and its O-ring keeps fluid from seeping past the gear retainer. Small leaks often show up as drips on the cable housing or grime near the connector. Because transfer case fluid can run down the cable, a leak can look like a larger problem than it is.
When replacing this seal, drain or check the fluid level first and clean the area around the retainer so debris does not enter the case. Use the fluid type your vehicle requires, and inspect the speedometer gear for wear or damage while the cap is off. Lubricate the new O-ring lightly with the same fluid to help it seat without tearing.
- Clean the connector before removing the cap
- Check fluid level after reinstalling
- Inspect the speedometer gear for wear
- Replace the cable seal if it looks worn
Specifications
| Brand | Jeep |
|---|---|
| Part number | 6035709 |
| UPC | 70000432847 |
| Component | Speedometer pinion O-ring |
| Application | NP231 transfer cases |
| Fitment listing | Direct Fit |
Vehicle fitment
The O-ring is for NP231 transfer cases. Confirm the transfer case type against your vehicle before comparing it with your original seal.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
An O-ring, with no other parts. Verify it against your installation plan before starting.









