Overview
The Jeep 6508914AA is a banjo mounting bolt for the Jeep Wrangler (JK) from the 2008 and 2013 model years, covering the Sahara and Unlimited Sahara. It is a factory style replacement part that fits 2-door and 4-door models.
Key features
- Factory style replacement part
- Fits 2-door and 4-door models
- Banjo mounting bolt
Banjo bolt sealing basics
A banjo bolt passes through the hollow fitting and clamps it to the component, so the fluid path depends on proper sealing at both faces. The washers on either side compress to seal, which means they are usually replaced whenever the bolt is removed. Keep the fitting clean and make sure the banjo sits square before the bolt is tightened.
Leaks at a banjo joint are often traced to reused washers, a fitting that is not fully seated, or a bolt tightened unevenly. After installation, check the joint for seepage with the system at operating temperature, then recheck the fluid level. Torque figures belong in the service procedure for your model, and that procedure should be followed rather than estimated.
- Replace both crush washers each time
- Wipe the joint dry and recheck for drips
Specifications
| Brand | Jeep |
|---|---|
| Part number | 6508914AA |
| UPC | 70000547625 |
| Part type | Banjo mounting bolt |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2008 and 2013 Jeep Wrangler (JK), Sahara and Unlimited Sahara.
Other JK model years are not on this list. Confirm your vehicle’s year, model and trim before ordering.









