Overview
The JcrOffroad DIY Prerunner Side Tubes, part DIY-PRESD, are 1-1/4 inch round steel tubes roughly 17.5 inches long, sold bare and made in the USA. They are the side sections for a DIY prerunner-style front bumper.
JcrOffroad says these are the same side tubes used on the XJ Prerunner and the JK Dagger builds. No vehicle is named as a fit for the tubes themselves.
Key features
- 1-1/4 inch round tubing
- Roughly 17.5 inches long
- Bare steel, unpainted
- Made in the USA
Building a prerunner bumper
A prerunner bumper frames the front of the truck and usually carries the lights, a winch plate or a brush guard. The side tubes set the width and the angle of that frame, so their placement decides how the finished bumper sits and how it clears the grille and fenders. Mocking the layout with clamps before any welding is a practical way to check that before the metal is joined.
Bare steel tubing is prone to rust at cut ends and weld spots, so plan the finish, whether paint, powder coat or a primer, before the bumper goes on the truck. Dry-fit every joint, check the tubes sit square to each other, and recheck clearance to the radiator and hood after the final tack. Keep mounting hardware and gusset plates aligned with the frame rails, since a bumper that flexes will crack its welds over time.
Specifications
| Brand | JcrOffroad |
|---|---|
| Part number | DIY-PRESD |
| UPC | 70000777712 |
| Tubing | 1-1/4 inch round |
| Length | Roughly 17.5 inches |
| Finish | Bare |
| Material | Steel |
| Origin | Made in the USA |
Vehicle fitment
The tubes are used in XJ Prerunner and JK Dagger builds. Confirm the tube size and mounting suit your build before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
These tubes are a fabrication part, so they are cut, mounted and welded into a bumper build rather than bolted on.
What’s included
Side tubes only. Mounts and a bumper center section are not included.












