Overview
Part number ICO26523 is a front nitrogen-charged monotube shock with an internal reservoir, sized for a 2.5 inch lift. It fits 2018–2026 Jeep Wrangler JL and 2020–2026 Jeep Gladiator models.
ICON designs the 2.0 Aluminum Series as an upgrade for daily street driving and weekend off-road use. Each shock can be rebuilt and revalved. Heavier off-road use is better matched to the 2.5 Series.
The valving is vehicle specific, and each shock can be rebuilt and revalved to retune the damping later. A minimum 1 inch bump stop spacer is required, and it is supplied with the 2.5 inch coil spring kit.
Shocks are sold individually, so a pair is needed for the front axle. Confirm the vehicle model before choosing, since the Wrangler JL two-door and four-door models and the Gladiator are the vehicles covered.
Key features
- Premium 5-weight shock oil that holds damping across a wide temperature range.
- One-piece linear and digressive piston with vehicle-specific valving.
- 5/8 in chrome plated hardened steel shaft that resists corrosion and pitting.
- 6061 aluminum rod end, top cap and internals.
- Polyurethane bushings, zinc plated sleeves and forged steel mounting stems.
- Nitrile rubber top-out bumper for quiet operation, and fully rebuildable and revalveable.
Service and rebuild over time
A monotube shock with an internal reservoir can be serviced rather than thrown away when its damping fades. Rebuilding replaces the seals, the shaft bushings and the oil, and a revalve changes the feel of the shock. Both jobs are easiest when the shock is removed from the truck and mounted in a vise, so plan the time before the shock starts to wear badly.
Front shocks on a Wrangler or Gladiator work hard on washboard and rock. Check the shaft for pitting and scoring, the rod end for play and the bushings for cracking. Keep the shaft clean after mud runs, since grit can cut the seal and shorten the rebuild interval.
- Check the shaft for scoring or pitting
- Look for oil on the body after trail use
- Inspect polyurethane bushings for cracks
- Confirm bump stop spacer fit before installation
Specifications
| Brand | ICON Vehicle Dynamics |
|---|---|
| Part number | ICO26523 |
| Shock series | 2.0 Aluminum Series |
| Lift rating | 2.5 inch |
| Position | Front |
| Shock type | Monotube |
| Body | 6063 anodized aluminum |
| Shaft | 5/8 in chrome plated hardened steel |
| Charge | Gas charged |
Vehicle fitment
It fits the 2018–2026 Jeep Wrangler JL two-door and four-door, and the 2020–2026 Jeep Gladiator, across the trim levels covered. Wrangler JK and earlier Jeep models are not included.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A minimum 1 inch bump stop spacer is required with this shock. The spacer is supplied with ICON’s 2.5 inch coil spring kit.
What’s included
One front shock. The shocks are supplied individually, and the bump stop spacer is not part of this item.